Hager AE-47PNNLUS32D Installation Guide
Contents
1. HAGER COMPANIES DEVICES COVERED IN THESE INSTRUCTIONS 47DT Dummy Pull When Dogged A7NL Night Latch Key Retracts Latchbolt Rim Exit Device Double Door with SVR Device Vertical Rods 09 08 Surface Vertical Rod Exit Device 4700 Series Trim Installation Instructions Standard Duty 47CE Cylinder Escutcheon Key Locks amp Unlocks Lever 47BE Blank Escutcheon Always Operable Cylinder collar 47CE shown Cylinder locking plate Cylinder cam Trim actuating shaft Mounting posts Handing pin Lever handle Machine Screws Door Handing Outside of Door 1 4 20 Rim Exit Device Rim Exit Device Double Door with Rim Device and Double Door Strike SVR Device H Door ff Door Surface Vertical Rod Exit Device 1of3 4700 Series Trim Installation l HAGER Peta aMn Standard Duty COMPANIES INSTRUCTIONS 1 Set trim handing A Rotate lever handle to the right or left direction to match desired door handing B Insert square handing pin into hub as shown C For Surface Vertical Rod devices only be sure the handing matches what is indicated on the product box label Surface Vertical Rod handing cannot be changed in the field Note See back of trim for a label that indicates which direction to position handle for RHR or LHR handing The label also indicates which direction the trim actuating shaft should rotate PA Not applicable on eee n Left Hand Rev2. erse LHR N LHR ae Not applicable on pe Rim devices 1O A N Step 1A Door Handing Square Handing Pin Step 1B Insert Square Handing Pin 2 Install mortise cylinder A Remove key from mortise cylinder B Slide wave washer and cylinder collar onto mortise cylinder body C Screw mortise cylinder into escutheon trim with cam position as shown D Install cylinder locking plate and use provided screws to secure Wave Washer Position Cam pointing up Cylinder Collar Mortise Cylinder Cylinder Locking Plate Mortise Cylinder Step 2B amp 2C Install Mortise Cylinder Step 2D Install Cylinder Locking Plate 09 08 2of3 4700 Series Trim Installation l HAGER Peta aMn Standard Duty COMPANIES INSTRUCTIONS CONTINUED 3 Mark and drill mounting holes for escutcheon trim A Mark horizontal centerline by matching it to exit device centerline which can be found on push Trim side of door mounting B Apply template to door using centerline Refer holes to Applications section on page one to 1 2 determine location of vertical centerline Trim actuator shaft hole 7 Vertical centerline should match exit device 1 2 vertical centerline located on push side of door C Mark and drill 1 2 holes for mounting posts as I shown on template D Mark and drill 1 2 hole for trim actuator shaft A which mates with exit device not required for 47DT See exit device instructions for
3. further details 2 118 73 Ms See page one for details on your specific application 4 Install escutcheon trim A Insert trim mounting posts and Door actuating shaft through door B Mate trim actuating shaft with cam on back of exit device C Secure from push side of door with provided 1 4 20 screws D Test installation by rotating lever handle or key to verify trim activates exit device Exit device mounting Note Dummy trim is only for pulling door The handle does not rotate a es Cam mates with trim ae actuating shaft 09 08 3 of 3
Download Pdf Manuals
Related Search