Home

Husky H4820 Instructions / Assembly

image

Contents

1. Operation 1 Operating the sander 2 Installing the sanding pad This Dual Action Sander is designed to operate on 90 PSIG WARNING Disconnect the tool from the air source before Lower pressure below 90 PSIG will reduce performance servicing or changing any accessories of the tool Higher air pressure over 90 PSIG raises the performance of the tool beyond its rated capacity and WARNING Always use the sanding discs with the rated could cause serious damage to the tool and the user tool RPM Lock the drive spindle in place before attaching the sanding pad B Rotate the spindle lock until the spindle lock engages with the drive spindle Hand tighten the sanding pad B ina clockwise direction Adjust the rotation speed by turning the air regulator to the maximum rotation speed 3 Removing the sanding pad 4 Sanding surfaces WARNING Disconnect the tool from the air source before WARNING You must wear ANSI approved eye protection servicing or changing any accessories AN during the operation failure to follow this may result in serious injury or damage to the operator Use the open end wrench C to secure the bearing seat then use your hand to loosen and remove the sanding pad B protective respirator is recommended A WARNING Hearing protection is strongly recommended A Connect the air sou
2. rce and run the tool Do not operate the tool with the spindle locked or the sander will stall when pressure is applied to the pad Always use the correct grit practical for the sanding operation

Download Pdf Manuals

image

Related Search

Related Contents

Bedienungsanleitung  Philips VGA cable for PC connection CRP887  TM-H6000II  UM SWD EN Think & Do  MANUAL DE INSTRUCCIONES MODELOS: EWIA16F5OEJ  ENGINE CONTROL SYSTEM SECTION EC  1.1 Matlab Recording & Analysis Program  アリクスト=皮下注ー5mg - グラクソ・スミスクライン  KOHLER K-7305-K-CP Installation Guide  安全データシート  

Copyright © All rights reserved.
Failed to retrieve file