Hessaire MFC1600 Use and Care Manual
Contents
1. Replacement Parts Portable Evaporative Cooler No Description PEC1500 1 Evaporative Media 16132 2 Evaporative Media Frame Assembt 10875 3 Set Of 4 Keepers 110871 4 10439 5 10698 Model PFC1500B Read And Save These Instructions NOTICE This Product May Temporarily Produce An Odd Odor When First Turned On This Is NORMAL And Will Dissipate After A Few Hours Evaporative Cooling Evaporative cooling is an economical way to cool Air is cooled while being drawn across wet evapora E 2 a tive media The movement of this fresh cooled air over the skin is what makes it feel cool t is important S when using an evaporative cooler in an enclosed space to have adequate exhaust by opening windows doors etc Without an outlet to exhaust the air humidity will build up in the enclosed space and the unit will not cool adequately It is preferable to have an opening behind the unit to bring in fresh air and another opening across the room to exhaust and help move the air Safety Rules 1 Unit must be in the Off Position and Unplugged from power receptacle when performing any mainte nance ctric shock plug unit into a properly grounded receptacle 3 To reduce the risk of electric shock install only on a circuit protected with a Ground Fault Circuit Inter rupter GFCI 4 This appliance is not intended for use by persons including children with reduced physical sensor2. e a season or when Disk needed To clean the media rinse with clean water Light scrubbing might be necessary Be carefull not to damage media After about 2 years or when it becomes clogged the media will need to be re 45 ae placed To remove the media you will need to remove the plastic disk A fl from the stem Push the keeper stem through the keeper disk until f you can grab the disk to remove it Refer to fig 5 Keeper Stem When replacing the evaporative media install it so that the steeper 6 flute angle of the media is sloping down towards the media frame see 15 cms fig 4 Push the keeper stems through the media from the back of the media frame and press the keeper disks onto the stems to secure the media in place Clean Replace Pump On occasion you may need to clean or replace the pump To remove the pump from the unit remove the bracket securing the pump and disconnect the in line connector Clean any debris in the pump or hose and in reservoir Make sure when reconnecting the pump that the connectors are securely snapped in place and the pump is secured to the housing Trouble Shooting Problem Cause Remedy Cooler does not pump Pump is not activated Switch pump knob to a water Water level is low Fill with water and make sure Pump is activated Pump may be defective Replace pump Fan does not operate Check that unit is plugged into a power receptacle Check the fuse or breaker If c
3. onnected to a GFCT outlet check if it is tripped
4. ration This unit has three separate switches One for power one for pump and one for fan See figure 3 The fan switch has 3 position 9 A ands Push the switch to turn off the fan Turn the fan knob to position 9 to start the unit in low speed A for middle speed and for high speed Pump Cooler Operation To operate this unit as an evaporative cooler the unit must be filled with water and the pump powered off Push the pump switch to active pump To operate the unit as a fan only push the pump switch to Off Note Make sure to turn off both the fan and pump when not in use Maintenance AN WARNING Before doing any maintenance be sure nnit is unplugged Press Here Screw Remove Media Frame To remove the media frame first remove the two screws located at the top of the frame Press down at the top center of the unit near the media frame until it unsnaps from the media frame See Fig 4 Drain Unit The drain plug is located on the underside of the unit Remove this drain plug to drain water from the unit The unit should be drained periodically to keep the water fresh We recommend draining the unit once a week Drain the water from the unit when it will not be used for an extended period Make sure the drain plug is securely pushed into the hole before filling with water Clean Replace Evaporative Media Keeper The evaporative media should be cleaned twic
5. y or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should he supervised to ensure that they do not play with the appliance 5 Do Not operate any fan with a damaged cord or plug Discard fan or return to an authorized service facility for examination and or repair 6 Do Not rum cord under carpeting Do Not cover cord with throw rugs runners or similar covert Not route cord under fumiture or appliances Arrange cord away from traffic area and where it wi be tripped over wy 3 3 g E amp gt amp Do not AN WARNING To reduce the risk of fire or electric shock do not use this fan with any solid state fan speed contro device Operation Fill With Water Open the water access door by pressing firmly at the top of the door to unlateh it see fig 1 Fill with a pitcher or water hose Do Not Overfill Close the access door pressing firmly at the top of the door until it latches close Water Level Indicator On the front of the unit there is a window to view the level of water in the unit see fig 2 The red pointer of the indicator will be in the full position with water near the top of the reservoir As the water level is decreased in the unit the indicator will fall in the window until it reaches the Low indicator Fill unit with water when low Fan Ope
Download Pdf Manuals
Related Search