Rod Desyne CT4884-15 Installation Guide
Contents
1. UNIVERSAL ROD INSTRUCTIONS 1 Extendable Rod 2 Baton 3 Clips 4 Carriers for clip or drapary pins 5 Wall Bracket with outer larger inner smaller rod clamp NOTE 1 This is one way draw with baton 2 Drapery pins are sold separately AL WALL MOUNT INSTALLATION CEILING MOUNT INSTALLATION oO O The smaller Clamps are for the inner smaller Rod section and the larger Clamps are for the outer larger Rod section Position Brackets in desired end locations on wall and mark the mounting hole locations Position the other Braket s evenly between these end Brackets and mark these holes as well Brackets should never be more than 48 apart and must be level with each other Note where the larger outer Rod ends and be sure the appropriate sized Clamp is used in each location Screw the Brackets to wall using the long screws provided Note If the desired hole locations are not over a wall stud Anchors provided are required for proper installation refer to Anchor instructions Loosen projection adjustment bolt slightly so Clamp can slide on Bracket Attach Rod to middle Bracket s first Twist Clamp using a flat blade screwdriver clamping onto the Rod and tighten in place Repeat for all Brackets Adjust Rod at each Bracket to desired projection from wall and tighten the adjustment bolts for curtain panel Attach a Clip onto the end cap of Rod on the end yo2. lip to each Carrier as well Starting from the Clip on the end cap install curtain panel onto Clips for drapery pins Starting from the stationary end hook each pin already attached along top of drape into end cap and each Carrier Attach Baton onto last Carrier AL
3. u want your curtain to be stationary Attach a Clip to each Carrier as well Starting from the Clip on the end cap install curtain panel onto Clips for drapery pins Staring from the stationary end hook 1st pin already attached along top of drape into endcap and into each Carrier Attach Baton onto last Carrier Unbolt Rod Clamp assembly from Wall Bracket and set wall Bracket and Bolt Nut aside The smaller Clamps are for the inner smaller Rod section and the larger Clamps are for the outer larger Rod section Position Rod Clamps in desired locations on ceiling and mark the mounting hole locations Position the other Clamp s evenly between the end Clamps and mark these holes as well Clamps should never be more than 48 apart and must be in a straight line with each other Note where the larger outer Rod ends and be sure the appropriate sized Clamp is used in each location screw Rod Clamps into ceiling using the long screws provided Screws are to be kept loose for now Note If the desired hole locations are not on a stud toggle bolts sold separately are required for proper installation Attach Rod to middle Clamp s first Twist Clamp using a flat blade screwdriver clamping onto the Rod and tighten in place Repeat for all Clamps Tighten the ceiling mount screws for curtain panel Attach a Clip onto the end cap of Rod on the end you want your curtain to be stationary Attach a C
Download Pdf Manuals
Related Search