Rod Desyne 100-04-99-3 Installation Guide
Contents
1. INSTALLATION INSTRUCTIONS FOR ROD SET NOTE Finial shown is for illustration purpose only It may not represent the style of finial purchased Place brackets against wall at desired locations If screws are going directly into wood trim or Mark screw holes with pencil Be sure marks are wall stubs drill a 1 8 pilot hole at pencil marks Assemble rod and sheer drapery level across opening l If screwing into drywall follow drywall anchor treatment onto rod instruction in the bottom of the page measure D 0 d MOUNTING FINIALS PIC 1 PIC 2 There are two diameters of screw finials onto rod rotate finial on rod Push and turn insert into the end of the pole white inserts included For a for proper alignment if required until base of the finial is sung to insert face three piece rod there is only one diameter of white insert Turn the end of the finial screw clockwise Turn the end of the finial into flatted end of the white insert screw clockwise into flatted end of the white insert until base of the finial is sung to insert face see PIC 1 2 Push and turn each insert into the corresponding size end of the pole with the fins of the insert going into the k pow FLATTED END a 4 biggest CORRESPONDING SIZE line Y gt Extend rod to desired width Lift rod with drapery and drop into brackets Lock rods into position by tightening leveling screw by hand Adjust draperies to desired positi2. on until finger tight this will prevent the rod from moving If screws are going directly into wood trim or wall studs drill 1 8 3mm holes and install screws through bracket If screws are going into hollow wall drill 3 16 5mm holes and push or lightly hammer plastic anchors into holes Then install screws through brackets Do not tighten screws too much just snug is best DRYWALL ANCHOR INSTALLATION
Download Pdf Manuals
Related Search