Home

Aquatic 4834CPAN-BI Installation Guide

image

Contents

1. RESISTANT SILICONE SECTION DETAIL A WATERPROOF ADHESIVE BOND COAT 100 MILDEW RESISTANT SILICONE SECTION DETAIL B MEMBRANE REINFORCED MORTAR BED HESIVE BOND AT 1 MIN WATERPROOF MEMBRANE OVERLAPS TILE FLANGE Gas N AQUATIC Customer Service Technical Services Warranty Services 1521 No Cooper Ste 500 Arlington TX 76011 PH 800 945 2726 817 801 8300 FAX 866 544 5353 Printed in U S A LITID1 166 4 100 MILDEW RESISTANT SILICONE SECTION DETAIL C 2011 Aquatic
2. all construction debris before filling product for plumbing inspection Drain and wipe clean immediately after the inspection process Use sponge with warm water and liquid detergent Do not use abrasive cleaners such as scour ing powders or pads steel wool scrapers sandpapers or anything else that may scratch mar or dull the finish Roofing tar or paints may be removed with turpentine rubbing alcohol or paint thinner not lacquer thinner Plaster may be removed by scraping with the edge of a piece of wood or rigid plastic Do not use a metal scraper or utensil to remove plaster or paint from finish Dulled areas can be restored to a high gloss with white or cream colored automotive rubbing compound followed by application of a coat of good quality white automotive polish or similar and buff with a soft cloth Do not polish or buff on the standing or floor areas of the pan Remove minor scratches with 600 grit wet dry sandpaper followed by Step 3 above Major gouges require professional repair User Maintenance Instructions IMPORTANT Use only recommended cleaners and procedures described herein Use of other materials and methods may damage your bath fixture and void the warranty For normal cleaning Never use abrasive cleaners such as scouring powders or pads steel wool scrapers sandpaper or anything else that could scratch or dull the surface of your Aquatic unit Instead use warm water and liquid detergents or non abrasive clean
3. amp Installation Data AS Shower Pans 3232CPAN 3636CPAN 4242CPAN 4834CPAN 6030CPAN 6034CPAN AQUATIC Wa ee NOTICE Please inspect the unit thoroughly before installation to make sure it has not been damaged during transportation Under no circumstances should a damaged pan be installed Neither Aquatic nor the distributor will be responsible for removal or reinstallation costs should a replacement be necessary IMPORTANT Before installation begins a b C READ ALL INSTALLATION INSTRUCTIONS COMPLETELY IMPROPER INSTALLATION WILL VOID THE WARRANTY Make sure that walls and floors meet fire safety requirements of local building code and or FHA HUD Minimum Property Standards All dimensions are nominal The stud opening is 14 3mm 0 Pre Installation Requirements a In remodeling if necessary add studs at each end to provide a vertical nailing surface for the side nailing flanges of bath fixture product b To avoid obstruction during installation make sure that supply lines spout pipe and valve plumbing do not project into alcove c Shower pans require a 6 150mm diameter floor opening for 2 50mm IPS drain fitting connection See Chart 1 for location NOTE Be sure floor opening location matches left hand right hand or center bath fixture drain location d Locate rough plumbing valving according to the manufacturer s instructions Do not install trim at this time Installation m Make sure framed in a
4. d spread See Diagram 2 m Place pan into alcove with front skirt firmly on floor and depress plaster mounds Make certain that unit is level See Diagram 2 The pan must be set level a Spot fasten the four corners of the nailing flanges to studs above line on pan b Nail fasten at each stud through the topside flanges through back flange at each stud concrete 16 405mm on center working from both ends toward back center See Diagram 2 c Asan option a large head nail may be driven into place above the tiling flange m Finished Wall Coverings a For cultured marble walls Bring water resistant wall board down to the top of the flange Apply 100 silicone sealant with mildew resistant properties between the gypsum board and nailing flange Apply cultured marble over the gypsum board to the horizontal surface of the unit then seal the seams of the cultured marble See Diagram 3 Detail A b For ceramic tile with cementitious backer board Furring strips as thick as nailing flanges are recommended above the unit Apply concrete backer board to leave at least a gap of 14 between the backer board and the horizontal surface of the pan Apply 100 sili cone with mildew resistant properties between the backer board and the horizontal surface of the unit Apply finished wall tiles leaving the valley detail on the pan clear of all materials to allow trapped water to escape Finishing of other trades should be done in confor mance wit
5. h applicable codes and generally accepted building practices See Diagram 3 Detail B c For ceramic tile with traditional mortar bed Apply the waterproof membrane overlapping the flange of the unit 1 min Apply wire over the flange to leave a gap of 14 between the wire and the horizontal surface of the pan Apply the mortar bed to the second step of the pan leaving the third step clear for tile Apply 100 silicone with mildew resistant properties leaving the valley detail on the pan clear of all materials to allow trapped water to escape Finishing of trades should be done in conformance with applicable codes and generally accepted building practices See Diagram 3 Detail C m Door Enclosures Use Aquatic shower door model for an engineered fit or refer to other door manufacturer s installation instructions NOTE Where local codes specify minimum door openings shower stalls may require swing not sliding doors m 3232CPAN does not carry the UPC seal and is not approved by some municipal plumbing codes due to inside dimensions Check local building codes Aquatic e 8101 E Kaiser Blvd e Anaheim CA 92808 e 800 877 2005 e FAX 714 998 5340 e www aquaticbath com ers ware SS AQUATIC Clean up CAUTION DO NOT USE heat or solvent based cleaning fluids NOTE Do not remove adhered label Warranty User Maintenance Label must be left for occupant Required by ANSI Z124 i To prevent staining and or blistering Remove
6. his is a natural occurrence beyond Aquatic s control See Warranty CAUTION When using any cleaning or polishing materials make sure to read and follow all package instructions carefully Wear rubber gloves at all times and avoid contact with eyes skin clothing rugs and furnishings Make sure all residues are rinsed off thoroughly Aquatic e 8101 E Kaiser Blvd e Anaheim CA 92808 e 800 877 2005 e FAX 714 998 5340 e www aquaticbath com a 2 ma AQUATIC Rough In Dimensions OW o p fo RI DR DC Fax On Overall Overall Overall Roudh in Drain Diamerter Demand Width Depth Height 9 Drian Clearance Doc Approx Wt lbs kg 3232 CPAN 32 810mm 32 810mm 7 34 180mm 6 150mm 15 395mm 16 405mm 31 4 34 80mm 10mm 21 lbs 8kg N 36 915mm 7146 180mm 6 150mm 314 80mm 10mm 25lbs 9kg re 77a eD 20 20mm ss 8 Te tn sb 140 ma i Toe 20mm DETE na IGO ss 5 Chart 1 3636 CPA 36 915mm LEVEL LEFT TO RIGHT BOTH EXAMPLE OF FASTENED CASTING AT EACH PLASTER STUD MOUND Ce LINE rere Diagram 1 Diagram 2 Aquatic e 8101 E Kaiser Blvd Anaheim CA 92808 e 800 877 2005 e FAX 714 998 5340 e www aquaticbath com 3 es WATER RESISTANT GYPSUM BOARD N 100 MILDEW RESISTANT SILICONE STUD CEMENTITIOUS WATER RESISTANT CONCRETE BACKER BOARD CULTURED MARBLE SECTION DETAILS 100 MILDEW
7. lcove is of proper size per Aquatic dimensions See Chart 1 The stud opening is 14 8mm 0 square and plumb check floor for levelness m Place pan in alcove with the front skirt firmly on the floor The pan must be set level To check use a 3 915mm long minimum level on top of the ledge on both ends of pan and on top of dam See Diagram 2 m After leveling pan mark each stud or concrete or block wall immediately above the back horizontal flange Remove pan from alcove Pre drill and fasten flange above scribe line shown on pan See Diagram 2 NOTE Fasteners to wood framing 1 25mm galvanized roofing nails or 1 25mm pan head screws to steel studs drill flanges and studs with 36 5mm carbide bit and fasten with 10 x 1 25mm sheet metal screws with washers to concrete block walls use 1 25mm concrete nails with nailing tool or impacter NOTE Pre drilling flanges is required to prevent cracking of unit m Apply sanitary drain assembly per drain manufacturer s recommendations to the pan gm Additional bottom support Casting plaster plaster of paris herein referred as foundation materials is mandatory for shower pans The following applies for foundation materials In a bucket mix foundation material Place three or four mounds of plaster on the subfloor around but away from drain hole The mounds should be placed high enough so that when the pan is set it will cause the plaster to displace an
8. sers especially those bathroom cleaners recommended for cleaning fiberglass To keep your Aquatic bath fixture sparkling clean Apply a coat of good quality automotive paste wax or polish and buff to a high shine with a soft cloth or towel Repeat every six months for easier cleaning and long lasting protection NOTE DO NOT WAX floor bottom of unit which could result in greater risk of slipping and personal injury To restore a scratched or dull unit Use an automotive polishing compound applied with a clean cotton rag Rub scratches and dull areas vigorously Wipe off residues Follow with automotive wax treatment described above To remove adhesive Try 3 M Natural Cleaner De Solv It or similar materials If residues remain saturate a small white cotton rag with nail polish remover naphtha or acetone and rub vigorously until the adhesive dissolves and disappears These solvents are highly flammable and must be used sparingly and with caution Do not smoke or permit others to do so Make sure all nearby heating devices including pilot lights are extinguished Do not allow solvent to go down the drain Make sure not to contact plastic drain grates or other synthetic materials Rubber Mats If you use a rubber anti skid mat make sure to remove it from the unit after each use to avoid harm to the surface finish Hard Water Water in certain regions if not wiped up after bathing showering may cause fading of some bath fixture colors T

Download Pdf Manuals

image

Related Search

Related Contents

contributos para a gestão de sedimentos associáveis a infra  Kingston Technology ValueRAM KVR1333D3S4R9S/2GEA memory module  Model 250P for 1/32"  Eizo CG220 User's Manual  HRAT/N FF 0071Ö0121 serv IT    ONYX Swing-arm User`s Guide  

Copyright © All rights reserved.
Failed to retrieve file