Hunter 99119 Use and Care Manual
Contents
1. 7 26 13 Hunter Fan Company Door Phillips Head Screw Installing or changing the battery To access the battery compartment remove the small Phillips head screw that secures the battery door to the transmitter assembly Replace with a CR2032 battery when necessary The battery should be installed with the positive side up The Safe Exit Program gives you about thirty seconds of light when you turn the lights off to exit the room before the lights go out To use Safe Exit Press the Fan Off button for at least three seconds to initiate the Safe Exit Mode The lights will flash for visual confirmation The lights will stay on 50 brightness for 15 seconds and then begin to dim After a total of 30 seconds the lights will be completely off Note For CFL lighting the lights will stay on 100 brightness for 30 seconds After a total of 30 seconds the lights will be completely off AIMPORTANT Use the pull chain switch on the fan to set the fan speed to the HIGH position before operation Fan will not start e Make sure the power is on at the circuit breaker and the wall switch e Make sure the battery is working e Make sure that the transmitter and receiver are paired e Check wire connections inside of the canopy Remote control of fan is erratic e Make sure the battery is installed correctly e Install a fresh battery Transmitter only works when held at close range2. ED WARRANTY INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE VOIDED THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES THE DURATION OF ANY IMPLIED WARRANTY INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE IN RESPECT TO ANY CONTROL IS EXPRESSLY LIMITED TO THE PERIOD OF THE EXPRESS WARRANTY SET FORTH ABOVE FOR SUCH CONTROL This warranty excludes malfunctions or failures which were caused by repairs by persons not authorized by us mishandling improper installation modifications or damage to the Control while in your possession or unreasonable use This warranty does not apply to batteries or to deterioration or damage to the product caused by the use of faulty batteries To obtain a replacement return your Control postage prepaid along with proof of purchase to Hunter Fan Company Service Department at 7130 Goodlett Farms Pkwy Memphis TN 38016 IN NO EVENT SHALL HUNTER FAN COMPANY BE LIABLE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR THE EXCLUSION OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE If you have problems installing or operating your fan do not return this
3. This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help Note Any changes or modifications to the transmitter or receiver not expressly approved by Hunter Fan Company may void one s authority to operate this remote control
4. ded CONNECT WIRES FROM RECEIVER TO FAN Using the blue wire connectors connect the white wire from the receiver CONNECT WIRES FROM RECEIVER TO WIRES FROM OUTLET BOX Using an orange wire connector connect marked common out to the white wire from fan Connect the black wire from the receiver marked fan out to the the black wire ungrounded from the ceiling to the black wire from the receiver marked live in Connect black wire from the fan Connect the blue wire from the receiver marked light out to the blue wire or possibly black the white wire grounded from the ceiling to the white wire from the receiver marked neutral in with white stripe from the fan AFTER ALL WIRES ARE CONNECTED and secured with wire connectors re install the canopy If you re uncertain about wire colors or connections please contact a qualified electrician To avoid possible electrical shock before installing or servicing your fan disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location If you cannot lock the circuit breakers in the off position securely fasten a prominent warning device such as a tag to the service panel Turn the splices upward and push them carefully back through the hanger bracket into the outlet box Spread the wires apart with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box M0058 01 0
5. e Change battery Lights do not dim Check to see if a CFL bulb is installed The control has a feature that automatically detects CFL bulbs and turns off dimming if a CFL bulb is installed CFL bulbs flicker e Turn the light switch off and back on Within three minutes hold down the Fan Off button while pressing the Light button twice If the problem is not corrected repeat the process up to three times Note The remote must be paired before the fan will operate The Fan Off button only turns the fan off To turn the fan on press one of the Within 3 minutes of restoring power emueecise Mh Sine to the fan press both the Fan Off ooo High button and the High button for at least 4 seconds Your fan will turn on low to indicate successful syncing If it does o Low not turn off power to your fan wait 1 minute then try again If using the transmitter with multiple fans repeat this process for each fan oo Medium HUNTER FAN COMPANY CONTROL LIMITED WARRANTY The Hunter Fan Company makes the following limited warranty to the original purchaser of the Control Control Your Control is warranted to be free from defects in material and workmanship for a period of one year from the date of sale If the Control malfunctions or fails within the warranty period due to a defect in material or workmanship we will replace it free of charge IF THE ORIGINAL PURCHASER CEASES TO OWN THE CONTROL THIS WARRANTY AND ANY IMPLI
6. product to the dealer Call our Consumer Affairs Hotline 1 888 830 1326 M0058 01 07 26 13 Hunter Fan Company Quickly press the Light button to turn the lights off and on Hold the Light button to raise and dim the light level t www HunterFan com 1 888 830 1326 To install the transmitter cradle remove the two screws holding your switch cover plate Do not remove the cover plate Orient the cradle by lining up the two mounting holes with those on the cover plate Insert and tighten the screws Do not over tighten Read and Save These Instructions This product conforms to UL Standard 507 AWARNINGS This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation This device complies with RSS 210 of Industry Canada Operation is subject to the following two conditions 1 this device may not cause interference and 2 this device must accept any interference including interference that may cause undesired operation of the device This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part I5 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation
7. t www HunterFan com 1 888 830 1326 Universal 3 Speed Ceiling Fan Remote Recei For low profile fans the receiver should ee wf be secured to the ceiling bracket with a cable tie Receiver ili Cable Tie Baiona instelling the Remove the canopy If uncertain Choose the hanging system that most closely resembles the one used by your fan and install the receiver as shown and wire as directed Universe Remote conte how to remove it reference the fan s Receiver use the pull chains owner s manual With wiring exposed toset ine fope peedto HGH it may be helpful to note existing wire anel ihe hejm ONL BE connections or take a digital photo for You may have installation issues if the fan is installed on an angled ceiling For assistance call 1 888 830 1326 SE Poe ore Berre reference Remove the wire connectors preceeding wiih insialanon that connect the wires from the outlet box to the fan leaving the grounding wires connected Note Some fans may have considerable excess lead wire For easier canopy installation cut the excess wire leaving a minimum of 8 remaining Re strip the fan lead wires 1 2 Place remaining excess wire into the ceiling electrical box The bracket and fan must remain properly grounded fs blue light out TINA UAE black fan out i black live in black ungrounded white common out i white neutral in white groun
Download Pdf Manuals
Related Search