Sea Gull Lighting 44628-962 Installation Guide
Contents
1. Installation And Safety Instructions HC 1539 Sea Gull Lighting Line art shown may not exactly match the fixture enclosed However the installation instructions do apply to this fixture Fill in Item Number on Carton and File This Sheet For Future Reference ITEM 082409 IMPORTANT SAFETY INSTRUCTIONS CLEANING e Be sure the electricity to the system you are working on is turned To clean wipe fixture with a soft cloth Clean glass with a mild soap off either the fuse removed or the circuit breaker set at off Do not use abrasive materials such as scouring pads or powders e Use of other manufacturers components will void warranty listing steel wool or abrasive paper and create a potential safety hazard e If you are unclear as to how to proceed contact a qualified electrician e You don t need special tools to install this fixture ORDERING PARTS e Be sure to follow the steps in the order given Keep this sheet for future reference and in case you need to order e Read instructions carefully replacement parts Parts for this fixture can be ordered from place of e Save these instructions purchase Be sure to use exact wording from illustration when ordering parts BEFORE YOU BEGIN INSTALLATION Carefully remove the fixture from the carton and check that all parts IMPORTANT DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX are included as shown in figure 1 Be careful not to misplace any of the screws or parts which are needed to i2. ASSEMBLY STEP 5 Make sure no bare wires can be seen outside wire connectors After wires are connected tuck them carefully inside outlet box Push the canopy I firmly over the mounting screws F and against the wall Secure canopy I in place by threading cap nuts E onto fixture mounting screws F Place shade A on socket cup B and secure by threading retaining ring H onto socket STEP 7 Install lamps not supplied WIRE CONNECTOR RETAINING RING H as SHADE A SOCKET CUP B NOT INCLUDED
3. nstall this fixture STEP 1 Place back plate D against wall and mark location for drywall anchors Remove back plate D and drill appropriate sized holes into drywall for anchors Pull supply wires through appropriate opening in backplate D Place backplate D against wall and secure by installing dry wall screws into anchors Install outlet box screws not supplied into outlet box through appropriate openings in backplate D if applicable DRYWALL BACKPLATE FIXTURE GREEN SUPPLY WIRE ANCHOR D GROUND GROUNDING GROUND CONNECTOR WIRE SCREW G WIRE T MOUNTING SCREWS F FIGURE 1 NOT INCLUDED INSTALLATION continued HC 1539 STEP 3 A Use a listed wire connector to connect the fixture hot wire black wire or round and smooth tracer to the supply hot wire B Use a listed wire connector to connect the fixture common wire white wire or square and rigid to the supply common wire C Gently try to remove the wires from the connector If you can remove the wires carefully re do the wiring connection GROUNDING INSTRUCTIONS Connect the supply ground wire fixture ground wire and mounting bar ground wire pre attached using the supplied wiring connector Gently try to remove the wires from the connector If you can remove the wires carefully re do the wiring connection GREEN GROUNDING SCREW G BACKPLATE FIXTURE SUPPLY D GROUND GROUND WIRE WIRE MOUNTING SCREWS F 7 CAP NUTS E FINAL
Download Pdf Manuals
Related Search