Designers Fountain HC0580 Installation Guide
Contents
1. ASSEMBLY amp INSTALLATION INSTRUCTIONS Please read carefully and save these instructions as you may need them at a later date CAUTION Turn off the main power at the circuit breaker before installing the fixture in order to prevent possible shock GENERAL All electrical connections must be in accordance with local and National Electrical Code N E C standards If you are unfamiliar with proper electrical wiring connections obtain the services of a qualified electrician Remove the fixture and the mounting package from the box and make sure that no parts are missing by referencing the illustrations on the installation instructions ASSEMBLY AND INSTALLATION L Determine the desired length from the intended ceiling or mounting surface that you wish the fixture s SHADE 17 to extend down to Using the three different lengths of TUBES 12 13 14 provided determine which combination of tube lengths is going to give you your desired length and screw the TUBES 12 13 14 together using the NIPPLE 11 provided Thread a NIPPLE 11 on each end of the assembled TUBES 12 13 14 to be used on the fixture 2 Feed the SOCKET LEAD WIRES 7 amp 22 from the SHADE HOLDER UNT 19 through the TUBES 12 13 14 and the CANOPY 23 Screw the components together until they secured and do not come loose 3 Place the 8 32 HEX NUTS 24 onto the 8 32 FIXTURE MOUNTING SCREWS 5 and attach the FIXTURE MOUNTING SCREWS S5 to the MOUNTING B2. RACKET 6 or universal mounting plate whichever is provided Do not tighten the HXE NUTS 24 at this time 4 Pull the power supply wire out from the OUTLET BOX 1 and mount the MOUNTING BRACKET 6 or the universal mounting plate to the OUTLET BOX 1 using MOUNTING SCREWS 20 5 Attach the power supply wire to the fixture lead wire by connecting BLACK SUPPLY WIRE 4 to BLACK FIXTURE LEAD WIRE 22 and WHITE SUPPLY WIRE 2 to WHITE FIXTURE LEAD WIRE 7 Connect the FIXTURE GROUND WIRE 21 to the POWER SUPPLY GROUND WIRE 3 using a WIRE CONNECTOR 8 not included ASSEMBLY AND INSTALLATION Continued Place the CANOPY 23 on the fixture over the OUTLET BOX 1 and onto the FIXTURE MOUNTING SCREWS 5 and adjust the FIXTURE MOUNTING SCREWS 5 until they protrude out from the CANOPY 23 1 4 Remove the CANOPY 23 and secure the position of the FIXTURE MOUNTING SCREWS 5 by tightening the HEX NUT 24 against the MOUNTING BRACKET 6 Place the CANOPY 23 back onto the FIXTURE MOUNTING SCREWS 5 and secure into place using the DECORATIVE NUT 9 provided Unscrew and remove the THREADED SOCKET RING 18 from the EXTERIOR THREADED SOCKET 16 Slide the center hole of the SHADE 17 over the EXTERIOR THREADED SOCKET 16 and screw the THREADED SOCKET RING 18 back onto the EXTERIOR THREADED SOCKET 16 Place a light bulb into the EXTERIOR THREADED SOCKET 16 with the type and wattage rating specified on the lamp replacement marking located
3. on the fixture INSTALLATION IS NOW COMPLETED OUTLET BOX WHITE SUPPLY WIRE POWER SUPPLY GROUND WIRE BLACK SUPPLY WIRE FIXTURE MOUNTING SCREW MOUNTING BRACKET WHITE FIXTURE LEAD WIRE WIRE CONNECTOR DECORATIVE NUT SWIVEL NIPPLE 18 TUBE 12 TUBE 6 TUBE SOCKET CUP EXTERIOR THREADED SOCKET SHADE SOCKET RING SHADE HOLDER UNIT MOUNTING SCREW FIXTURE GROUND WIRE BLACK FIXTURE LEAD WIRE CANOPY 8 32 HEX NUT eee This product may not contain glass shade The drawing of glass shade shown in this instruction is a representative it may not match the glass shade you ordered
Download Pdf Manuals
Related Search