Aspects TPFW70050LWH Installation Guide
Contents
1. Caution Make sure power is off at fuse or circuit breaker box Check power wires for damage or scrapes If power supply wires are within three inches of the ballast power supply use wire suitable for at least 90C 194F Note Most dwellings built before 1985 have supply wire rated to 60C Consult a qualified electrician before installing A Attach gem bar 2 to junction box not supplied with two screws 1 B Attach threaded stem 4 to gem bar and secure it with the hex nut 3 Adjust threaded stem 3 in the gem bar 2 so approximately 34 is exposed C Make all wire connections to appropriate wire Secure with wire nuts supplied D Connect the green wires from the fixture and power source to the green screw on the gem bar 2 E The black wire from the fixture is connected to the black wire from power source F The white wire from the fixture is connected to the white neutral wire from power source G Tuck all connections neatly into junction box 3 Mounting A Align the backpan center hole over threaded stem 4 Secure the backpan with the thumbscrew 6 4 Shade Secure the shade 7 with four screws 8 5 Restore power at fuse or circuit breaker box Limited Factory Warranty American Fluorescent Corporation warrants this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 2 years from date of purchase This warr2. Outdoor Fixtures LED Ceiling Fixture Models 326926 326932 TPF W70050LWH TPFW110050LWH 120VAC 60Hz Safety Precautions This fixture is designed for use in a 110 120VAC 60Hz fused circuit Read all safety precautions and installation instructions carefully before Do not use on a dimming circuit installing or servicing this fixture Failure to comply with these instructions could result in potentially fatal electric shock and or To reduce the risk of electrical shock and to assure proper operation this fixture must be adequately grounded To accomplish proper property damage l D E a l grounding there must be a separate ground wire green contact fixture must be wired in accordance with all national and local supply panel electrical codes S o o l l l l This fixture is intended to be used for general outdoor lighting in dry or Do not handle any energized fixture or attempt to energize any fixture damp locations only with wet hands or while standing on a wet or damp surface or in water ASSEMBLY INSTRUCTIONS 1 Preparing for installation A Disconnect electrical power at fuse or circuit breaker box before installing or servicing any part of this fixture B Carefully remove the fixture from the carton and check that all parts are included as shown in figure below Be careful not to misplace any of the screws or parts which are needed for installing the fixture 2 Wiring all wiring must take place inside junction box
3. anty covers all component parts and extends only to replacement of defective fixture or components it does not cover failure due to improper installation misuse mishandling or damage incurred in transit 1 of 1 American 8060659 R2 Fluorescent lh design efficiency technology
Download Pdf Manuals
Related Search