Minka Lavery 953-126 Installation Guide
Contents
1. to the loops on center column B and the loops on arm N HANG THE FIXTURE Fig 3 1 Oo 11 12 Shut off the power at the circuit breaker and remove old fixture from ceiling including the old crossbar Carefully unpack new fixture and lay all the parts on a clear surface Thread nipple C into loop F until snug Thread other end of nipple C with loop attached into crossbar D until snug Place lock washer B over end of nipple protruding through crossbar and thread hex nut A onto nipple until tight Take this crossbar assembly and mount to ceiling junction box with junction box screws E Tighten screws securely with screwdriver Use a pair of pliers to open one end link of the chain provided and connect to the fixture loop J Close the link By measuring determine correct number of links needed for proper hanging height Using pliers disconnect and discard remaining chain Lace the fixture wires through the chain Slip loop collar H over the chain then do the same with the canopy G Open the other end link of the chain and hang the fixture on the loop at the ceiling Close the link Feed the fixture wires through the loop F and nipple C and pull until taut CONNECTING THE WIRES Fig 2 l Take the black wire from the ceiling junction box and the smooth wire leg from the fixture and twist bare ends together Twist wire connector onto end of wire until snug Repeat same process with white ju2. INSTALLATION INSTRUCTIONS FOR 953 126 WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER ASSEMBLY THE FIXTURE Fig 1 1 2 3 Thread the center column B into the center of main body G fit the loop A on top of center column B Install the light bulbs in accordance with the fixture s specifications DO NOT EXCEED THE MAXIMUM WATTAGE RATING Thread the pipe K onto bottom center of main body G and lock it securely with nut J Screw the nut W onto pipe K Put washer X and rubber ring Y over the pipe K Raise glass shade M to bottom of main body G Then position the finial base L below the glass shade Protruding the pipe K from base L and attach the base L to the fixture assembly V by lock it securely with hexnut O Four holes on fixture assembly V must be aligning with the holes of main body G Hook the slice side of arm N to hooks on the main body G aligning the hole on arm N with the hole of main body G then guide the other side through V attach collar ring I onto top side of arm N and lock securely with screw H attach collar ring Q on other side of arm N and tighten firmly with hexnut R Thread pipe S into hexnut O and tighten firmly with screw P Attach finial base T and tighten firmly with finial U Cover two glass plates F over main body G smooth side will be on the bottom attach collar ring E and lock securely with nut D Hook end of decoration chain
3. nction box wire and ribbed wire leg of fixture wire NOTE Twist wires together in the same direction you twist the wire connector onto wires If you junction box has a grounding wire green or bare copper attach this wire and the bare copper wire from the fixture together as step 1 If junction box has no ground wire attach the bare copper fixture wire to the green ground screw on the crossbar Tuck these wire connections neatly into the ceiling outlet box and then raise the canopy G all the way to the ceiling Raise the loop H and thread onto ceiling loop protruding through canopy Install the light bulbs in accordance with the fixture specifications NOTE DO NOT EXCEED THE SPECIFIED WATTAGE FIXTURE FIXTURE Q FIXTURE Q WIRES WIRES WIRES Q Black or White or ANN Bare FAN Smooth Ribbed L Copper HOUSE Ground HOUSE WIRES WIRES White Green or Neutral Bare Copper Ground Junction Box Ceiling A A B C Eom SE SS N 36 Z ILLS COD gt 1 eel ELOT IA lighting association Listed
Download Pdf Manuals
Related Search