Minka Lavery 4969-284 Instructions / Assembly
Contents
1. i LA A Crossbar through cross bar P and thread hex nut R onto nipple S until en een tight 4 Take this crossbar assembly and mount to ceiling outlet box V using outlet box screw W tightly The side of cross bar marked GND must face out 5 Use proper chain pliers to open one end link of the chain and connect to the fixture loop A Close the link l ni l Chain HCH3072 84 6 By measuring determine the correct number of links needed for SN Gauge 4 5MM proper hanging height Using the chain pliers disconnect and DAAA discard the remaining chain 7 Carefully lace the fixture wires through the chain X 8 Slip collar ring Y over the chain X then do the same with canopy U 9 Open the other end link of the chain X and connect to the collar loop T Close the link 10 Feed the fixture wires through the collar loop T and nipple S W Mounting screws 2 and pull until tight FOXT URE CONNECTING THE WIRE See fig 3 Moor a RIBBED Sg 1 At this point connect the electrical wires as shown in Fig 3 OR RCH ENT making sure that all wire connectors are secured If your outlet LACE w 28 box has a ground wire green or bare copper connect the ae ee fixture s ground wire to it Otherwise connect the fixture s ground Fig 3 RSD wire directly to the mounting plate using the green screw provided 2 Tuck these wires connectors neatly into the ceili2. INSTALLATION INSTRUCTIONS FOR FIXTURE 4969 WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR ASSEMBLING THE FIXTURE FIG 1 1 Shut off the power at the fuse box or circuit breaker If _ LOOP A necessary remove the old fixture including the mounting N CAP B hardware oe 2 Carefully remove the fixture from the carton and check that all eee ee parts are included as shown in the illustration iy eee 3 Thread the nipple G into the coupling H then secure tightly with the hex nut 4 Thread the other hex nut onto the other end of the nipple G then insert the cap B over the nipple G and secure tightly SKT RING 26 with the fixture loop A 5 CK ET RING C 5 Adjust the fixture arms to their proper position CUSHION RINGO 6 Place the glass shade E over the socket F then secure with GLASS SHADE E the cushion ring D and socket ring C o 7 Install the light bulb in accordance with fixture s specifications JK L SOCKET DO NOT EXCEED THE MAXIMUM WATTAGE RATING NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE MOUNTING THE FIXTURE FIG 2 1 Thread the nipple S into the collar loop T until snug 2 Thread the other end of nipple S into the cross bar P os gt 3 Place lock washer Q over the end of nipple S protruding Set A A 010
3. ng out let box and raise the collar ring Y and thread onto collar loop T protruding through canopy Your installation is now complete Return power to the outlet box and test the fixture Notice It is important to use proper chain pliers not e american included to OPEN and CLOSE the chain included with a this fixture Do not open them with other tools that may lig hting twist or stress the chain links It is important to use proper chain pliers like the ones shown in the diagram Intertek association
Download Pdf Manuals
Related Search