SPT SL-824T5 Use and Care Manual
Contents
1. Do not use excessive force when securing Socket SL 624 T5 Power Consumption 24W Power Supply 120V 60Hz Approx 22 4x27 56x19 67 in Weight 3 17 Ibs Replacement Bulb HO 27W IMPORTANT SAFEGUARDS IMPORTANT SAFEGUARDS Do not operate this lamp near a water source to avoid electric shock Do not dismantle Do not use with power supply other than 120V 60Hz Do not operate lamp in close proximity to flammable or combustible vapors such as aerosol spray or where oxygen is being administered Do not cut or shorten the power cord Always unplug lamp before performing bulb installation bulb replacement or maintenance This product may cause interference with radios cordless telephones or devices that use a wireless remote control such as televisions If interference occurs move the product away from the device plug the device or lamp in a different outlet or move the lamp out of the line of the remote control receiver Unplug the lamp during lightning storms or when unused for extended period of time All moisture should be properly wiped away and dried prior to use Do not touch bulb when lamp is on or s2. installation or failure to perform the necessary maintenance This GUARANTEE is in addition to your Statutory Rights SUNPENTOWN INTERNATIONAL INC 14625 Clark Ave City of Industry CA 91745 Tel 800 330 0388 service sunpentown com Ver 01 DRH R 84 12 www sunpentown com Thank you for your purchase please read all instructions before using Please keep this instruction manual in a safe place for future reference PARTS IDENTIFICATION If loose use a screwdriver to tighten Fixture Lamp Shade ees YS When installing make sure click is heard Light bulb Lid Dimmer control Aluminum arm Bottom cover Power switch Fixture When installing make sure click is heard Adjustment screw If loose use a screwdriver to tighten screws use of other tools may cause damage Clamp height increased insole BULB INSTALLATION REPLACEMENT INSTRUCTIONS Make sure lamp is powered off and unplugged from power source Wait until bulb is cool enough to handle Bulb is hot immediately after powering off e Removal 1 Turn bulb 90 degrees and remove from socket i e Installation 1 Align base of bulb to notch on the socket Turn bulb until a click is heard Note Handle with care do not drop Do not replace anything other than the bulb Only replace with HO 24W bulb SPECIFICATIONS Use a coin or flathead screwdriver A N Attention
3. LAMP INSTALLATION When table or surface thickness is less than 2 cm please use the insole to Do not install lamp Surface that is too thin or fragile to support lamp Limited surface space for clamp Add the Height Increase Insole when surface thickness is less than 2cm On a pole or Horizontall uneven surface y Your Guarantee If this product is found to be faulty as a result of faulty materials or workmanship within one year from date of purchase it will be repaired free of charge This guarantee is subject to the following terms e Sunpentown must be notified of the fault e Proof of purchase must be presented to Sunpentown s nominated representative e The warranty will be void if the product if modified misused or repaired by an unauthorized person e The warranty after repair will not be extended beyond the original one year period e All replacement parts will be new or reconditioned e Parts which are replaced become the property of Sunpentown e The warranty applies for the use of the product in the USA only What is NOT COVERED e Warranty does not include freight charges S L 82415 e Incidental or consequential damage caused by possible defects with this product T 5 Fluorescent Task Lam D e Damage to product caused by improper power supply voltage accident fire floods or acts of nature e Failure of product resulting from unauthorized modifications to the product e Improper
4. hortly after powering off May cause burns Dispose of bulbs per local regulations MAINTENANCE Before cleaning make sure lamp is powered off and unplugged Allow sufficient time for the bulb to cool down Periodically wipe the lamp with a soft damp cloth Use a mild non abrasive cleaner if needed e All liquid should be properly wiped away and dried prior to restoring power Do not use solvents or abrasive cleaners
Download Pdf Manuals
Related Search