Sea Gull Lighting 82007-71 Installation Guide
Contents
1. GHER NOTE This glass is handcrafted the slight imperfections in the glass add to the authenticity of the fixture FINIAL A HOOD E CAGE D SOCKET COVERS G FIGURE 1 INSTALLATION HC 657 STEP 1 A Take note of the color of the wire s on your fixture Identify which group your fixture wire s falls into and connect the wires according to the directions below GROUP A CONNECT TO BLACK GROUP B CONNECT TO WHITE HOUSE WIRE ___ _ PE CUMHOUSE WIRE WIRE BLACK WHITE a PARALLEL WIRE ROUND amp SMOOTH PARALLEL WIRE SQUARE amp RIDGED NOTE When parallel wire is used the tracer wire is square shaped or ridged and the less tracer wire is round in shape or smooth Seen best when viewed from wire end To separate wires grasp the ends of each wire and pull apart Ss B Take your fixture wire s from group A and place evenly against the black wire from the outlet box Do Not twist wires together before using wire connectors C Fit a wire connector not supplied over the wires and thread the connector clockwise until you feel a firm resistance D Gently try to remove the wires from the connector If you can remove the wires carefully re do steps B and C as above and check again for a firm connection E Connect the fixture wire from group B to the white wire from the outlet box in the same manner STEP 2 GROUNDING INSTRUCTIONS Connect the ground wire from the fixture2. Installation And Safety Instructions HC 657 Sea Gull Lightin Line art shown may not exactly match the fixture enclosed However the installation instructions do apply to this fixture Fill in Item Number on Carton and File This Sheet For Future Reference ITEM 092010 IMPORTANT SAFETY INSTRUCTIONS NOTE FOR FIXTURES THAT ARE SOLID BRASS e Be sure the electricity to the system you are working on is turned Your handcrafted solid brass lighting fixture has been coated off either the fuse removed or the circuit breaker set at off with a durable baked on acrylic lacquer which gives e Use of other manufacturers components will void warranty listing maximum protection against the weather In time however the and create a potential safety hazard brightness of the brass will tarnish giving way to an authentic e If you are unclear as to how to proceed contact a qualified old world brass finish electrician NOTE To keep your solid polished brass fixture looking new for years to come regularly apply a good quality non abrasive car wax to all metal surfaces giving the fixture an extra protective coating e You don t need special tools to install this fixture e Be sure to follow the steps in the order given e Read instructions carefully e Proper wiring is essential for the safe operation of this fixture e Save these instructions WARNING NOTE DO NOT INSTALL ON A POST OR A POLE THAT RESULTS IN A VERTICAL RISE OF 25 FEET OR HI
3. bare metal or green insulated wire to the ground wire from the power supply bare metal or green insulated wire using a small wire connector not supplied NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES STEP 3 Slide fitter F onto post Secure in place with screws FINAL ASSEMBLY Make sure no bare wires can be seen outside wire connectors STEP 1 Install socket cover G if applicable STEP 2 Install lamp STEP 3 Install hood E onto nipple S and secure by threading finial A onto nipple S CLEANING To clean wipe fixture with a soft cloth Clean glass with a mild soap Do not use abrasive materials such as scouring pads or powders steel wool or abrasive paper ORDERING PARTS Keep this sheet for future reference and in case you need to order replacement parts Parts for this fixture can be ordered from place of purchase Be sure to use exact wording from illustration when ordering parts
Download Pdf Manuals
Related Search