Sea Gull Lighting 8338-10 Installation Guide
Contents
1. INSTALLATION AND SAFETY INSTRUCTIONS WARNING BE SURE THE ELECTRICITY TO THE WIRES YOU STEP 1 ARE WORKING ON IS SHUT OFF EITHER THE FUSE REMOVED OR THE CIRCUIT BREAKER OFF Carefully remove the fixture from the carton and check that all parts are included as shown in Figure 1 Be careful not to misplace any of GENERAL the screws or parts which are needed to install this fixture You don t need special tools to install this fixture Be sure to follow the steps in the order given Under no circumstances should a fixture be hung on house electrical wires nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system Read instructions carefully If you are unclear as to how to proceed consult a qualified electrician NOTE Proper wiring is essential for the safe operation of this fixture WIRE CONNECTORS OUTLET BOX MOUNTING PLATE J GROUND WIRE OUTLET BOX SCREWS MOUNTING SCREWS 2 L NOT SUPPLIED FIGURE 1 ITEM Fill in item number located on carton and file this sheet for future reference HC 301 042397 INSTALLATION HC 301 IMPORTANT DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX Place mounting plate J against outlet box not suppplied and screw in place using outlet box screws not supplied A Take note of the color of the wire s on your fixture Identify which group your fixture wire s falls into and connect the wires according to the direction2. d ground wire is on the mounting plate connect the ground wire from the fixture if supplied and the outlet box to it using a small wire connector not supplied NOTE Underwriters Laboratories U L does not require all fixtures to have ground wires These fixtures still meet all U L specifications The listing mark of Underwriters on the product identifies products manufactured under its listing and Follow Up Service Programs NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES FINAL ASSEMBLY Make sure no bare wires can be seen outside wire connectors STEP 1 After wires are connected tuck them carefully inside the outlet box Position backplate M over mounting plate J and secure in place with mounting screws L STEP 2 Install lamps CLEANING To clean wipe fixture with a soft cloth Clean glass with a mild soap Do not use abrasive materials such as scouring pads or powders steel wool or abrasive paper ORDERING PARTS Keep this sheet for future reference and in case you need to order replacement parts All parts for this fixture can be ordered from place of purchase Be sure to use exact wording from illustration when ordering parts WET LOCATION NOTE FOR FIXTURES LABELED FOR WET LOCATION AND USED OUTDOORS CAUTION To reduce the risk of electrical shock provide a watertight seal between the fixture and the mounting surface by using a silicone or similar caulking
3. s below GROUP A CONNECT TO BLACK GROUP B CONNECT TO WHITE __ HOUSE WIRE HOUSE WIRE BLACK WHITE PARALLEL WIRE ROUND amp SMOOTH PARALLEL WIRE SQUARE amp RIDGED WHITE OR GREY WITH TRACER WHITE OR GREY WITHOUT TRACER Se TTE BROWN GOLD OR BLACK WITHOUT BROWN GOLD OR BLACK WITH TRACER TRACER nnn NOTE When parallel wire is used the tracer wire is square shaped or ridged and the less tracer wire is round in shape or smooth Seen best when viewed from wire end To separate wires grasp the ends of each wire and pull apart B Take your fixture wire s from group A and place evenly against the black wire from the outlet box Do Not twist wires together before using wire connectors C Fit a wire connector not supplied over the wires and screw the connector clockwise until you feel a firmness D Try gently to pull the connector off the wires If you can pull the connector off carefully re do steps B and C as above and check again for a firm connection E Connect the fixture wire from group B to the white wire from the outlet box in the same manner STEP 3 GROUNDING INSTRUCTIONS The green grounding screw is to be inserted into the hole with two raised dimples provided on the mounting plate Wrap the ground wire from the fixture if supplied and the ground wire from the outlet box bare metal or green insulated wire around the green grounding screw on the mounting plate If uninsulate
Download Pdf Manuals
Related Search