Mont Blanc 50400NSC Instructions / Assembly
Contents
1. Thermocast installation Guidelines Important Before you Begin Read all instructions carefully before beginning installation Remove the sink from its original carton and inspect it for damage Return the sink to its protective carton until you are ready to place it into position in the countertop Inspect your faucet hardware to insure that all components exist for a successful installation as outlined in the faucet and or hardware installation guide Inspect the waste and supply lines and replace if necessary SELF RIMMING INSTALLATION con t STEP NINE Mount the faucet hardware on the sink following the manufacturer s instructions STEP TEN Install the drain in accordance with the manufacturers instructions using Plumbers Putty following the manufacturer s instructions Note Silicone Sealant or any other sealants other than Plumbers Putty should not be used as a replacement for Plumbers Putty Apply a thin continuous bead of 100 silicone sealant to the underside outer perimeter of sink approximately 1 4 inside the perimeter and carefully position the sink in the opening Remember that the sink rests on a layer of silicone sealant not dry fitted to the countertop STEP ELEVEN Verify that the sink has not moved out of position and immediately remove any excess sealant filling any remaining voids as needed STEP TWELVE Allow the sealant to cure at least 1 hour before proceeding STEP THIRTEEN Install the garbage waste disposer if a2. pplicable following manufacturer s instructions GASKET STEP FOURTEEN Connect the drain assembly STEP FIFTEEN Connect the faucet supply lines following the faucet manufacturer s instructions STEP SIXTEEN Carefully turn on the water supply lines then turn faucet on and check faucet drain and drain assembly for leaks to insure a completed successful installation of your new Thermocast Cast Acrylic Sink UNDER COUNTER INSTALLATION When planning to use a Thermocast sink in an under counter installation please check style and size before authorizing cutting of the countertop For under mounting to granite or marble or solid surface materials contact your granite marble solid surface fabricator for installation requirements and proper fasteners Under counter installation kits are available but not required or necessary by all professional fabricators Please contact Thermocast Sales Support for details regarding under counter installation kits ADDITIONAL ACCESSORY HOLES Please contact the Thermocast Sales Support Center for questions and or instructions on adding accessory holes to your new Thermocast sink THERMOCAST A DIVISION OF INTERNATIONAL THERMOCAST CORPORATION 308 Bell Park Drive Woodstock Georgia U S A Sales Support Center 678 445 2022 www thermocastsinks com
Download Pdf Manuals
Related Search