Con-Tact 24F-C9E98-06 Use and Care Manual
Contents
1. CON TACT LINER CREATIVE COVERINGS Self Adhesive SURFACE PREPARATION Clean surfaces prior to application as necessary All surfaces should be dry clean and smooth APPLICATION Measure area to be covered Carefully cut to fit using the lines on the backing paper as a guide Leave approximately 1 8 overlap on all edges for probable shrinkage over time Start at a corner and peel off the backing paper to apply Smooth from center out to help eliminate bubbles of air CLEANING AND MAINTENANCE Clean by simply wiping the surface with a damp cloth and mild soap if necessary REMOVAL Peel adhesive liner off of covered surface piece by piece To remove excess adhesive apply a citrus based solvent to the surface where the contact paper was applied Allow the solvent to sit for approximately 5 minutes to dissolve the remaining adhesive Scrub the surface with a sponge to remove adhesive residue Rinse the sponge in clean water and wipe the surface to remove any excess solvent Leave doors and drawers open to allow the interior of cabinets and drawers to dry To remove stubborn pieces first heat the surface to loosen the adhesive s grip e g blow dryer on low setting then follow the steps listed above KE NITTRICH CLL ott Oe ee La Mirada CA tel 714 736 1000 fax 714 736 2078 customer service 800 321 1741 email contactus kittrich com
Download Pdf Manuals
Related Search