Edsal TP3618W Instructions / Assembly
Contents
1. A ines i aN W W OR A UY Ly Mil WG ane y 1 Add a wire deck shelf to the previously built level then continue by adding the fourth and fifth level to the unit using two 2 beams and two 2 braces per level Tap lightly to properly seat the rivets and add the final wire deck shelves to the unit Install all four 4 end caps to the top of the unit after assembly has been com pleted see figure E Instali end caps to post by pressing down on end cap at the three points illustrated above see figure F2. MODEL NUMBER Heavy Duty Steel Shelving TP3618W od ETAT WA F Post Cap These units should be placed on a level surface Failure to do so can result in poor product performance or create a possible safety hazard This unit shouid be securely anchored to a wall or floor with suitable fasteners which are not included Do not use this unit for anything other than the manufactures intended purpose DO NOT STAND ON ANY PART OF THE UNIT OR USE IT AS A LADDER Evenly distribute the weight on each level and always keep the heavier loads on the bottom Use care when working with metal parts General Instructions Assembly is done with the rivets of the beams and braces fitting into the slots of the post A rubber mallet may be used on the beams and braces to seat the rivets properly A hammer can also be used providing one uses a cloth or a block of wood between the hammer head and the parts to prevent damage Tap gently and be sure the rivets are straight and fully engaged Should you have any comments damage missing parts or problems with assembly of this unt please feel free to contact our Muscle Rack manufacturing faciity at 773 475 3137 and request customer service nik Prodiicta Dhati We can also be reached on the internet at the following email address service edsai com Edeal Manufacturing Company 4400 South Packers Avenue To obtain replacement parts plea
3. se provide the following information Craeages u 60000 Model _ Part amp Description Location Purchased Date Purchased Tap Lightly v Shelf Ledge 8QG32 AAN of Post Siet Points Down Postare directional The siot must point Figure Assemble two 2 post with one 1 brace Skipping one slot from the bottom of the post see figure A place the rivets into post with the slot pointing down and with the shelf ledge of the brace facing up see figure B Tap lightly to seat riv ets Repeat with two 2 post and one 1 brace Assemble the two 2 post units with two 2 beams see figure C Skip one hole from the bottom of post tap lightly to seat rivets ANT NOTE Make Add a wire deck shelf to the previously built level then assemble the top post to the bottom post by using two 2 beams and two 2 braces One 1 rivet from each beam and brace must be placed in the top hole of the bottom post and the bottom hole of the top post see figure D After all beams and braces are in place tap lightly to properly seat the rivets Start by adding a wire deck shelf to the level previously built then continue working by adding the second level using two 2 beams and two 2 braces in the post slots of your desired location Again place the rivets of the beams and braces into the post slots with the shelf ledge facing up and tap lightly to seat the rivets ene wA 404 ee W A 4
Download Pdf Manuals
Related Search