Builders Edge 060010965018 Installation Guide
Contents
1. 9 Window Header Header Installation Instructions Kit Contains 1 pc Window Header 1 pc Window Header Base 12 pcs Shutter Loks Screws quantity is dependent on header length Window Header Optional Keystone also available for reducing size joining 2 units or for decorative detail Step 1 Begin by removing the Window Header from the Window Header Base This can be accomplished by disengaging the locking tabs Figure 1 at right shows the location of these tabs Note Depending on the size of your Window Header Kit there may be more or less locking tabs To release the locks start in the middle of the Header Assembly and pull the wall of the Header away from the Header Base Continue this process working your way to the ends of the Window Header Assembly Step 2 Draw a horizontal line 1 8 above the window trim This line will be used to properly space the Window Header from the window trim See Figure 2 at right This will allow for proper clearance between the window and the Window Header ieee oe window trim Draw horizontal line 1 8 Step 3 Center the Window Header Base over the window and spaced 1 8 above the window trim Use the elongated slots in the Header Base and attach the base to the house using the screws provided Alternatively the preferred method is to use Shutter Loks The raised portions of the Header Base with the round holes receive the Shutter Loks Atta2. ch Shutter Loks by drilling 1 4 holes into the wall Be sure not to fasten the screws or Shutter Loks too tightly to allow for expansion and contraction See Figures 3A and 3B at right Length Min of screws 3358 6 3758 8 amp 8 4358 8 O Note Figures 4A amp 4B at right show cross sections of the Window Header in place In some instances the Window Header may rock on the high point of the siding To overcome this problem insert the screws or Shutter Loks into the wall evenly See Figure 4A at right Insert the screws or Shutter Loks evenly working between top and bottom Step 4 With the Window Header Base securely fastened to the wall attach the Window Header by snapping it into place See Figure 5 at right Shutter Lok Application CORREC INCORRECT Fig 4A Fig 4B LL 8 7 01 PAPC9411 1 0067
Download Pdf Manuals
Related Search