X10 Wireless Technology MS10A User's Manual
Contents
1. Motion Detector Model MS10A Set Up and Operating Instructions Installation 1 Install four AA alkaline batteries in the battery compartment on the MS10A Observe polarity 4 Set the slide switch on the back of the MS10A to 1 to trip the alarm if only one movement is detected most sensitive Set to 2 to trip the alarm only after 2 movements are detected helps prevent false alarms 4 Press the CODE button on the back of the MS10A with the point of a pencil 5 Set the INSTALL RUN switch on the Security Console to INSTALL 6 Press TEST on the MS10A The Console emits a tone and the next unused zone indicator lights up 7 Set the Console s slide switch back to RUN1 or RUN2 8 To set up additional Motion Detectors up to 16 repeat the above steps Note you can install a total of 16 zones in the Console This can be a combination of Door Window Sensors and Motion Detectors E G 8 Door Window Sensors AND 8 Motion Detectors See your Security System Owner s Manual for more information eo oj ee ee P IL R MOTION DETECTOR Operation When the Security System is armed using a Key Chain Remote the Motion Detector will always trip the alarm when it sees motion When the system is armed using an SH624 Remote Control it can be armed in the Home or Away mode When armed in the Home mode Motion Detectors will NOT trip the alarm Place the Motion Detector on a bookshelf or attach it to a2. ial and workmanship for a period of one 1 year from the original date of purchase at retail X 10 USA Inc agrees to repair or replace at it s sole discretion a defective X 10 product if returned to X 10 USA Inc within the warranty period and with proof of purchase If service is required under this warranty 1 Return the defective unit postage prepaid to X 10 USA Inc at the address below 2 Enclose a check for 4 00 to cover postage and handling 3 Enclose a dated proof of purchase 4 X 10 is not responsible for shipping damage X 10 USA Inc 91 Ruckman Rd Closter NJ 07624 http www x10 com MS10A 998DR
3. wall about 6 feet off the ground using the supplied mounting bracket Wait about 45 seconds for the Motion Detector to settle then walk past it If the Console is NOT armed and in the RUN2 mode you will hear a chime If the Console IS armed the Motion Detector will trip the alarm and sound the siren After you walk past the Motion Detector it will not see motion again for about a minute conserves battery power Replacing batteries Slide the battery compartment cover off and replace the battery with a 9V alkaline type After replacing the battery the following steps are necessary to determine that the Console still recognizes the MSI0A 1 Place the Console s slide switch to RUN2 2 Press TEST on the MSIOA If the Console chimes it recognizes the MS10A and no further action is necessary If the Console did not chime 1 Place the Console s slide switch to INSTALL 2 Press TEST on the MS10A The MS10A s red indicator light flashes and MS10A transmits a random code to the console The Console acknowledges this with a beep and logs in the MS10A to the next available zone To make sure the Console logs the MS10A back into the same zone it was allocated to before you changed the battery wait 4 hours after removing the old battery before reinstalling until the zone indicator on the Console starts flashing X 10 USA INC LIMITED 1 YEAR WARRANTY X 10 USA Inc warrants X 10 products to be free from defective mater
Download Pdf Manuals
Related Search