Whirlpool GI15NFLTS User's Manual
Contents
1. INSTRUCTION SHEET for Ice Maker Trim Kit Full Door Models Only NOTE Customer must supply 6 flat head wood screws to mount wood panel of customers choice Follow the steps below 1 Remove old door handle 2 Remove nameplate Nameplate is held in place with adhesive tape 3 Install trim to wood panel of customers choice See illustration Recommend using eight 8 6 flat head wood screws approximately 1 2 in length Screws supplied by customer Please check length before installation 4 Lay customer panel and trim on door and mark the holes using the trim as your template 5 Using an drill bit drill eight 8 holes on the side of door as shown See illustration 6 Install panel and trim with eight 8 screws supplied in the kit 7 Install new door handle supplied using the old mounting screws Custom Panel Dimensions NOTE Customer Panel shown must be 1 9 cm thick and requires the following changes for clearance These changes must be made on both sides of the panel as shown Route Approximately 1 0 cm 1152 3 73 cm eM Mier Y Ya 635 cm 34 1 905 cm Thick Panel Cutting Notes 1 Match woodgrain direction with that of adjacent cabinets 2 Cut panel to dimensions as shown in illustration 3 Sand panel edges to provide smooth finish 4 Important Use moisture resistant sealer on both sides and all edges of panel for moisture protection 1999 All Right2. s Reserved Door handle mounting screws 6 Flat head wood q screw 1 2 long 8 supplied by customer 293 74 9 cm 142 36 9 cm N J Screw Customer 8 18 x 3 8 supplied panel Recommend 34 1 9 cm thick wood panel Instruction Sheet 2185921 Rev A 7 99
Download Pdf Manuals
Related Search