Targus PAKP003U User's Manual
Contents
1. the Receiver Plug the USB receiver into an available USB port on your computer ES oO Sy ae Lock LED Setup Key The Lock LED light turns on You are now ready to set the identification code to establish a communication link with the receiver 4 Targus wireless keypad and opitcal mouse combo Setting the Identification Code After your computer detects the USB receiver you must set the ID code between the receiver and the mouse as well as between the receiver and the keypad BEFORE you can use them To do this do the following NOTE Make sure that your computer is turned on and has detected the USB receiver before you set the ID code Optical Mouse 1 Press and release the setup key on the receiver The Lock LED light turns off 2 Press the setup key on the bottom of the mouse Setup Key power swtich When the LED on the receiver is lit the mouse is set up with an ID and the receiver is locked You are now ready to use the mouse Targus wireless keypad and opitcal mouse combo Wireless Keypad 1 Press and release the setup key on the receiver again 2 Press the setup key on the keypad When the light emitter diode LED on the receiver is lit the keypad is set up with an ID and the receiver is locked You are now ready to use the keypad Using the Keypad Activate Num Lock LED illuminated Definition of the keys Num I Bk Sp Lock 7 8 9 4 5 62. 1 2 3 Enter 0 00 Deactivate Num Lock Definition of the keys Num j Bk Sp Lock E Home T PgUp gt End L PgDn Enter Ins Del Targus wireless keypad and opitcal mouse combo Power Management To power the keypad and mouse on and off slide the on off switch to the desired position When power is on the mouse goes into power saving mode after 4 minutes of inactivity To activate the mouse move the mouse or press any button To save battery power turn off the keypad and mouse while traveling or when you re not using them CAUTION Removing the batteries will require you to y reset the ID code Operating Hints For optimal performance and RF reception e Place the receiver at least 20 cm away from all electrical devices such as your monitor speakers or external storage devices If necessary use the supplied extension cable to keep the receiver away from the computer Plug the receiver into the extension cable and the extension cable to the computer Avoid using the optical mouse on a metal surface Metals such as iron aluminum or copper shield the radio frequency transmission and may slow down the mouse s response time or cause the mouse to fail temporarily e The mouse will enter a suspend mode at the same time your computer does To activate the mouse press any of the buttons If your computer has a metal case that contains aluminum or m
3. I 7D Margus Visit our Website at www targus com Features and specifications subject to change without notice 2006 Targus Group International Inc and Targus Inc PAKPOO3U 410 0015 001A wireless 7 B keypad and opitcal mouse Vargus combo USER GUIDE CE PMS Black E PMS Black 30 100 TARGUS WIRELESS KEYPAD AND OPTICAL MOUSE COMBO Introduction Congratulations on your purchase of the Targus wireless keypad and opitcal mouse combo This combo set offers the latest technology for interference free operation with 27 MHz wireless connection and 4 096 IDs per channel Both keypad and mouse feature on off switch and auto power saving management for effective power conservation Contents In addition to this user s guide this package contains Targus Wireless Keypad Targus Wireless Optical Mouse USB Receiver USB extension cable 4 AAA batteries 2 for mouse 2 for keypad Carrying pouch System Requirements Hardware e PC with an Intel Pentium processor or equivalent e USB 1 1 interface Operating System Windows 98SE Me 2000 XP Targus wireless keypad and opitcal mouse combo NOTE The third button and the scrolling wheel of the mouse only work with the operating systems listed above If you use the mouse with a different operating system it will lose its enhanced features and function as a Standard two button mouse Installing the Batteries Optical Mouse 1 R
4. agnesium use the optical mouse to the side The display panel may interfere with the radio frequency signal if you use the mouse directly in front of the computer 7 Targus wireless keypad and opitcal mouse combo e Never use the optical mouse on a glass or mirrored surface as these surfaces will cause the mouse to fail temporarily e To maximize battery life use the optical mouse on a white or light colored surface Dark surfaces cause the mouse s LED to glow brighter which causes the battery to discharge more rapidly Comfortable Usage Research suggests that physical discomfort and injury to nerves tendons and muscles may be related to repetitive motion an improperly set up work area incorrect body posture and poor work habits To reduce the risk of injury follow these precautions e Stand stretch and move around several times every hour e Switch hands while performing tasks Use shortcut keys to avoid repetitive or awkward mouse movements e Relax your shoulders and keep your elbows at your sides Adjust the keyboard s position so that you don t have to stretch to reach it Adjust your position so that you don t have to bend your wrists to type avoid placing your wrists on a sharp edge If you feel discomfort or numbness in your hands wrists arms shoulders neck or back while typing consult a qualified medical professional Things to Remember Batteries General e You must reset the ID cod
5. e every time you change the batteries Targus wireless keypad and opitcal mouse combo e To extend the life of your batteries turn off the mouse and keypad while not in use and during travel Power Saving Mode e The mouse s power saving mode feature activates after 4 minutes of non operation To activate the mouse move the mouse or press any button Troubleshooting What do do if the mouse does not work e Make sure that the polarity of the batteries is correct The positive and negative ends of each battery must match the positive and negative connections in the battery housing e Check that the receivers USB connector is firmly attached to the USB port on your computer e Verify that the device drivers are installed e Make sure you have established a communication link between the mouse and its receiver See Setting the Identification Code Targus wireless keypad and opitcal mouse combo When I use the mouse other wireless devices work more slowly or fail tempor arily what should I do The mouse may cause interference with any cordless radio based device that operates at 27 MHz such as a telephone baby monitor or toy To reduce interference move the mouse s receiver and the base unit of the affected device as far away from each other as possible You can also reset the mouse s identification code The mouse has 4096 identification codes that allow the mouse and its recei
6. emove the battery cover from the top of the mouse by pressing the top center over the Targus logo and sliding it back lt Removing the battery cover 2 Insert the supplied batteries making sure that the positive and negative ends of each battery match the polarity indicators inside the battery housing WARNINGS When replacing the batteries you may use alkaline or other heavy duty NiMH batteries Never combine an alkaline with a NiMH battery in a device Avoid mixing new and used batteries in a device 3 Slide the battery cover back into position until it clicks firmly into place 4 Turn on the mouse by sliding the on off switch on the bottom of the mouse to the on position The optical sensor located on the bottom of the mouse glows red Targus wireless keypad and opitcal mouse combo Wireless Keypad 1 Remove the battery cover located on the bottom of the keypad 2 Insert the supplied batteries making sure that the positive and negative ends of each battery match the polarity indicators inside the battery housing Setup Key hae Power Switch D Targus setup N SiG g 8 o Homel t Poup Num Lock LED 3 Turn on the keypad by sliding the Power switch on the right side of the keypad to the on position Connecting
7. ons may cause harmful interfer ence to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna e Increase the separation between the equipment and receiver e Connect the equipment into an outlet on a circuit different from that to which the receiver is connected e Consult the dealer or an experienced radio TV technician for help Changes or modifications not authorized by the party responsible for compliance could void the user s authority to operate this product Declaration of Conformity Hereby Targus declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999 5 EC Intel and Pentium are registered trademarks of Intel Corporation Windows is a registered trademark of Microsoft Corporation All other trademarks are the property of their respective owners 2006 Targus Group International Inc and Targus Inc Anaheim CA 92806 USA 12
8. ver to operate without interference from other radio frequency devices To do this see Setting the Identification Code What do do if the response time of the mouse is slow or the mouse intermittently stops working Try one or more of the following Increase the distance between the mouse s receiver and the rest of your computer equipment Increase the distance between the mouse s receiver and the base units of other wireless devices Turn off any wireless devices and their base units that are near the mouse s receiver If you are using the mouse on a metal surface move it and the receiver to a non metal surface Metals such as iron aluminum or copper shield the radio frequency transmission and may slow down the mouse s response time or cause the mouse to fail temporarily Replace the batteries can t use the mouse while another RF mouse is in use what should do Reset the identification code See Setting the Identification Code 10 Targus wireless keypad and opitcal mouse combo Technical Support For technical questions please visit US Internet www targus com support asp Australia Internet www targus com au Email infoaust targus com Telephone 1800 641 645 New Zealand Telephone 0800 633 222 Product Registration Targus recommends that you register your Targus accessory shortly after purchasing it Go to http www targus com registration asp You will need to provide
9. your full name email address phone number and company information if applicable Warranty Targus warrants this product to be free from defects in materi als and workmanship for one year If your Targus accessory is found to be defective within that time we will promptly repair or replace it This warranty does not cover accidental damage wear and tear or consequential or incidental loss Under no conditions is Targus liable for loss of or damage to a devices nor loss of or damage to programs records or data nor any consequential or incidental damages even if Targus has been informed of their possibility This warranty does not affect your statutory rights Regulatory Compliance This device complies with Part 15 of the FCC Rules Opera tion is subject to the following two conditions 1 This device may not cause harmful interference and 2 This device must accept any interference received including interference that may cause undesired operation 11 Targus wireless keypad and opitcal mouse combo FCC Statement Tested to Comply This equipment has been tested and found to comply with the limits of a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructi
Download Pdf Manuals
Related Search