Sony VPCCW13FX/B Replacement Instructions
Contents
1. 2 3 VPCCW Series Optical Disk Drive Replacement Instructions Step 12 Align the tabs on the bezel Step 13 Position the new ODD Label Step 14 Firmly but carefully hold the with the tab holes located on the ODD side down and identify the correct ODD and begin the re installation of the screws amp brackets place mounted Notice the different shapes for each bracket and the way the available screw holes should align ODD Reinstallation Steps 7 11 Note Flat surface of bracket should sit flush with silver side of ODD Step 15 To install the new drive hold Step 16 Carefully slide the optical the optical drive by the edges and align drive into the bay and back into place it with the bay opening Step 19 Reinstall the battery pack and AC Adaptor Return the old ODD to Sony following the included shipping instructions Step 17 To ensure proper assembly Step 18 Re install the 2 previously and connection with even force push removed screws the ODD back into place Optical drive should be sitting flush with the edge of the computer P N 989200671 Rev A 3 32. SONY VPCCW Series Optical Disk Drive Replacement Instructions IMPORTANT PLEASE READ BEFORE YOU START These easy instructions are intended to guide you through the replacement process v Before you begin place your notebook computer on a clean or covered surface to avoid damage to the computer s case v Follow the ESD Electrostatic Discharge damage prevention instructions o Hold parts by the edges away from exposed circuitry when possible o Donot walk around excessively as this promotes static build up v Remove jewelry before you begin work to avoid scratching the surface of your notebook computer v The appearance of the electronic components shown in the illustrations may be different from the components shipped This slight difference does not affect the accuracy of these instructions Sony is not responsible for damage caused by incorrect handling of the notebook computer Mi Hemm Step 1 Prepare the Computer A caution Make sure the computer is turned off the lid is closed and the AC Adapter disconnected Failure to do so an result in damage to the computer Place the computer upside down on a protected surface with the front edge facing you P N 989200671 Rev A Step 2 Remove the Battery Pack Locate the release tab as shown in the picture 1 Slide the left battery tab to the Unlock position 2 With your finger slide the right battery tab in the release direction
3. and hold Hook your finger under the battery pack and lift 1 3 ll ODD Removal Steps 3 6 Step 3 Locate ODD Bay Rotate the computer with the Optical Disk Drive ODD Bay facing you as shown in the picture SONY Look for the screw hole with 3 dots Step 4 Using the enclosed magnetic screwdriver remove the 2 screws securing the optical drive VPCCW Series Optical Disk Drive Replacement Instructions Step 5 To initiate the removal of the Step 6 With even force carefully remove the optical drive by pulling it away from the unit optical drive slightly pull the optical drive door as shown in the picture Slight force may be needed _ to disconnect drive from connector Step 7 Carefully remove the ODD assembly ODD Disassembly Steps 8 10 Step 8 After the ODD is completely removed identify the 4 side screws that mount the ODD brackets to the ODD Step 9 Firmly but carefully hold the ODD Remove the screws amp brackets and set them aside The screws amp brackets will be used on the new ODD provided Step 10 Bracket amp screws should now be removed Please arrange the bracket amp screws as shown above Set old ODD aside P N 989200671 Rev A al ODD assembly Steps 11 14 Step 11 Take the new ODD and bezel provided in the CRU kit and prepare for assembly Note Identify tabs on the bezel and tab holes located on the ODD
Download Pdf Manuals
Related Search