Sanyo LNS-S02Z User's Manual
Contents
1. installing or replacing the lens be sure to check the following for safety 1 Check the lens is securely fixed by 4 screws 2 Check no wiring is tangled on the gear of lens motor or the other mechanical parts 3 Check no part is missing or no mounting part is loose some parts are not used for installation or replacement Keep these parts for later use Note Figures in this manual may be differ from the actual product LENS REPLACEMENT AND INSTALLATION PROCEDURE Perform the steps to for lens replacement and installation UPPER LENS COVER C REMOVE THE LENS COVER See figure 1 1 Remove screws A 2 screws 2 Pull down the lower lens cover while pushing the part D then remove it 3 Remove screws B 2 screws 4 Remove screws C 2 screws and remove upper lens cover LOWER LENS COVER REMOVE THE COVER PLATE OF THE LENS COVER See figure 2 Remove 2 screws and pull down the plate At the step 4 insert the light block sheet in the same position as the removed cover plate has been placed Two screws are not used COVER PLATE INSTALL THE LENS See figure 3 1 Remove protective caps front and back on the lens 2 Mount the lens on mounting bracket of the main LENS MOUNTING BRACKET cabinet with 4 screws Use the screws included with the lens Use the driver included with the lens to fasten the screws After using save it for latter use 3 Connect the lead connector of the lens m2. LCD PROJECTOR LENS MODEL NO LNS S02Z LENS REPLACEMENT AND INSTALLATION PROCEDURES NOTES ON REPLACEMENT AND INSTALLATION The procedures and the needed pars for lens installation depend on the type of cabinet Before installing or replacing the lens make sure the type of cabinet and be sure to refer to the Installation Manual corresponding with your projector When installing or replacing the lens make sure the Lens Model No matches with your projector Refer to the catalog or contact your sales dealer for the proper Lens Model No TYPE OF THE CABINET AND REFERENCE INSTALLATION MANUAL Refer to the Installation Manual corresponding to your projector See the chart below Type of the Cabinet Reference Installation Manual Refer to this manual Other than the above cabinet Refer to the Installation Manual design supplied with the Projector NOTES ON LENS INSTALLATION e Lens installation and replacement should be made by the qualified service personnel e Be sure to install the lens following this procedure precisely e The lens cover is on the lens for protection Be sure to replace the lens cover before installation e When installing or replacing the lens be careful not to stain scratch or damage the lens LIST OF CONTENTS Following parts are included in the packing e LENS 1 pc e LENS MOUNTING SCREWS 2 pcs for spare e DRIVER 1 pe e LIGHT BLOCK SHEET 1 pe N BE SURE TO CHECK FOR SAFETY After
3. otor to the K16B on the circuit board as shown in figure 4 4 Fasten the lens motor lead at the A B points with wire holder as shown in figure 4 Figure shown inside of the cabinet LENS MOTOR A WIRE HOLDER LENS MOTOR LEAD Fig 4 omc CONNECTOR K16B INSTALL THE LIGHT BLOCK SHEET See figure 5 Install the light block sheet around the lens as shown in the illustration Use the sheet included with the lens Set the light block sheet so that the large rounder side is set over the lens 41 its Set the light block sheet so that the large rounder side is set over the lens LIGHT BLOCK SHEET Fig 5 MOUNT THE LENS COVER See figure 6 UPPER LENS COVER When in install the both upper and lower lens cov ers install the light block sheet so that it should be placed in the guide slot of the lens cover If the installation of the light block sheet is incorrect there will be the space between lens and the lens cover so that it will be the cause of leakage of light or the dust entering at the main cabinet 1 Insert the upper part lens cover and fix them with screws A 4 screws 2 Insert the lower part lens cover and fix them with screws B 2 screws LOWER LENS COVER Fig 6
Download Pdf Manuals
Related Search