Quantum DLT RACK 1 Installation Guide
Contents
1. Using the Rack Mount Kit To Install the DLT Rack1 Chassis in an Equipment Rack Step 1 Remove the chassis members from the slides and attach the chassis members to the chassis Use 4 M3 x 4 mm pan head PHILLIPS screws See Figure 1 Chassis Chassis Chassis member Figure 1 Step 2 Loosely mount the left and right cabinet section bracket assemblies into the rack between the upright rails see Figure 2 Use these screws and washers e 4 10 32 x 3 8 pan head PHILLIPS screws e 4 10 flat washers Upright rails Left side assembly shown right side assembly is opposite Note Do not fully tighten the screws between the rack and the bracket at this time After loosely installing both brackets y in the rack securely tighten the rear bracket screws onto the slide Figure 2 Step 3 Install the chassis assembly from Step 1 into the cabinet sections Cabinet section bracket assembly a Move the ball retainers in the cabinet sections to the fully forward position b Slide the chassis sections through the plastic lead in guides at the front of the cabinet sections and into the balls c Make sure that the chassis sections are both fully engaged with the balls in the ball retainers d Press to release the lock on each slide then fully close the slides Step 4 Align the slides a Open and close the slides twice making sure the chassis sections engage in the cabinet sections properly and t2. ets in the rack securely tighten the rear bracket screws onto the slide Figure 2 Step 3 Install the chassis assembly from Step 1 into the cabinet sections Cabinet section bracket assembly a Move the ball retainers in the cabinet sections to the fully forward position b Slide the chassis sections through the plastic lead in guides at the front of the cabinet sections and into the balls c Make sure that the chassis sections are both fully engaged with the balls in the ball retainers d Press to release the lock on each slide then fully close the slides Step 4 Align the slides a Open and close the slides twice making sure the chassis sections engage in the cabinet sections properly and that the locks function properly b Securely tighten the front bracket screws onto the slide
3. hat the locks function properly b Securely tighten the front bracket screws onto the slide Information in this document is subject to change without notice Copyright 2003 2004 by Quantum Corporation All rights reserved Reproduction in any manner without the prior written permsision of Quantum Corporation is strictly prohibited Trademarks Quantum is a trademark of Quantum Corporation registered in the U S A and other countries Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products Quantum Corporation disclaims any proprietary interest in trademarks and trade names other than its own Part Number 81 81209 02 Rev A01 Using the Rack Mount Kit To Install the DLT Rack2 Chassis in an Equipment Rack Step 1 Remove the chassis members from the slides and attach the chassis members to the chassis Use 6 M3 x 4 mm pan head PHILLIPS screws See Figure 1 Chassis member Chassis Chassis member Figure 1 Step 2 Loosely mount the left and right cabinet section bracket assemblies into the rack between the upright rails see Figure 2 Use these screws and washers e 4 10 32 x 3 8 pan head PHILLIPS screws e 4 10 flat washers Upright rails Left side assembly shown right side assembly is opposite Note Do not fully tighten the screws between the rack and the bracket at this time After loosely installing both brack
Download Pdf Manuals
Related Search