PYLE Audio PLVWAN1 User's Manual
Contents
1. Powered Diversity TV Antenna PYLE VIEC W PLYWANI Installation Manual Parts Supplied 1 TV Antenna 2 2 Power Cord Holder 6 3 Antenna Cable Holder 4 4 Cigarette Light Plug 1 5 Seal 2 q Antenna Loading coil Note Use only on vehicles with 12 14 4 Volt battery Avoid short circuits by disconnecting the negative battery cable before beginning installation Protect the wiring by wrapping adhesive tape around exposed areas Antenna wires should not get in contact with moving parts areas of hot or sharp surfaces Avoid installing in areas that may get wet with rain Failure to do so may result in fire or electrical shock Proper Location Mount the antenna on the inside rear window of the car For optimum reception mount the antenna pointing down See Fig 2 e Leave a minimum of 1 inch space between the antenna wires and the edge of the window Location should not impair driver s view Do not mount near or next to an existing antenna e Be certain that there is enough cable to reach the unit e Trial fit the antenna do not remove protective paper from booster or antenna sections Wiring the Antenna Prior to the final installation temporarily connect the wires to make sure that all connections are made properly andto make sure that the system works properly Install the 4 antenna plugs into the TV tuner and the Cigarette light plug into2. amp Antenna Performance e Acar with a rear defroster or heating refract film can deflect the signal which causes poor reception Please check the type of glass and film before installing the product Install this product on the inside of the car Therefore in some cases image of television can be affected Weak signals can be the cause of poor image or sound Heater fan and other functions of the car can affect the TV reception Tunnels or buildings can deflect the signals Specifications TV ANTENNA POWER DC 12 14 4V e AUX TYPE MINUS MAX POWER AMP 50mA OUTPUT TERMINAL 3 5 MINI PLUG 2 1PCS LENGTH OF THE ANTENNA CABLE 16 54 INCHES SIZE OF THE BOOSTER AMP SECTION 2 56 2 13INCHES WEIGHT 470G INCLUDING CABLE 1PCS A Z ACCESSORIES POWER CORD HOLDER 6 e ANTENNA HOLDER 4 BODY COVER 2 INSTRUCTION BOOK 1 CIGARETTE LIGHT PLUG 1 Note Parts or design are subject to change without notice
3. the lighter outlet Note The cigarette lighter plug maybe removed and the red power wire may be connected to a12 volt switched power source by using a5 amp fuse not provided Check with a meterto be certain that the 12 volt power is switched or battery drain will occur The black wire should have a 6 ting terminal crimped on not supplied and connected to chassis ground Caution while Installing the Antenna Install the antenna onto the inside glass so it does not fall down while driving e Install on a clean glass surface Moisture can cause the antenna to fall down Low temperature decreases the adhesion Therefore turn on the heater if temperature is below 68 degree Fahrenheit Do not touch the sticky part of the tape e Keep the distance between the side of window and antenna element to a minimum of 1 inch Touching the windows can affect the transmission e Do not run the antenna cables next to power or speaker leads or noise problems can occur Installing the Antenna Thoroughly clean the glass area with a clean cloth and glass cleaner Be certain temperature of the glass is above 68 degrees Fahrenheit Remove the protective tape and mount the booster section Remove the protective tape and mount the antenna wire sections Make certain that antennas are securely installed with antenna holders provided Stick the protective seal on the outside of the window to hide the sticky part of the booster
Download Pdf Manuals
Related Search