Peavey WFM 1 User's Manual
Contents
1. A Street P O Box 2898 Meridian MS 39302 2898 601 483 5376 Telex 504115 Fax 601 484 4278 1991 80301496 Printed in U S A 111912. L EMEY WFM 1 ide Gu Operators LEVEL ANTENNA FPELVEY INT EXT 7 nS 9 TA 9 7 10 POWER WFM 7 MADE IN U S A 7 4 Intended to alert the weer to the presence of unineuleted 7 POE dangerous voltage within the product s enclosure thal may be SATION Blobs of Mee OO NO OEM Seiten Rinda aora chook to CAUTION To reduce the risk of electric shock do not remove cover No persons User serviceable parts inside Refor Sorvicing to qualified service personaal Intendod to alert the user tothe proseno of important operating ang maintenance servicing instructions inthe literature accom ppanying the product Introduction Congratulations and thank you for purchasing the WFM 1 FM tuner The WFM 1 is cost effective approach for FM background foreground music systems everywhere This small ready Mount unit delivers high performance reception via its fold down telescoping rod antenna or you may opt for an external antenna Termination is provided for 75 ohm or 300 ohm external antenna systems Operate direct to the speaker system via the on board 3 5 watt amplifier at 8 ohms or select the line output and connect to higher power when needed Either mode you select the WFM 1 delivers solid long term reliable performance in virtually any installation Features FM broadcast band 88 108 MHz Accepts 75 ohm and 300
3. M 1 to the wall using four screws 2 Plug the power supply adaptor Peavey part 70900660 3 Tune to the desired frequency radio station by adjusting the antenna and tuning knob 4 Setthe Levelto the desired listening volume Connection Diagrams 1 Connecting the WFM 1 directly to speakers 82 S SI SI SI 1 Si wewm1 connect the WFM 1 to speaker connect the LO terminal on the WFM 1 to ground on the speaker and connect the HI terminal on the WFM 1 to live on the speaker 2 Connecting the WFM 1 to a power amplifier Line input AMPLIFIER Output To connect the WFM 1 to a power amplifier connect the LINE LO of the WFM 1 to the ground of the amplifier connect the LINE Hl of the WFM 1 to the positive on the amplifier Connect the speakers to the amplifier as described in the instructions for the amplifier Using an external antenna 3000 or 750 750 load from Fod Roof style antenna 3006 twin lead antenna Regardless of the output method chosen the WFM 1 allows you to connect and external antenna for use with the tuner To connect 30022 antenna attach the wires to the two screws marked 3002 To connect a 75 Q antenna connect the coaxial cable rom the antenna to the 759 antenna input provided on the WFM 1 Specifications Audio Section Output Power 3 5 watts RMS into 8 ohms Frequency Response 50 Hz to 20 kHz 1 dB To
4. ohm antennas Built in telescoping rod antenna Select output or speaker output Level control 3 5 watt output into 8 ohms Built in wall mount bracket WFM 1 Controls Descriptions POWER WFM 1 3 MADE IN U S A 1 position Terminal Strip This is used to connect to the output source either speakers or an external amplifier The terminal strip also allows you to connect an external antenna 30022 and 750 connections are provided 2 Antenna Switch This switch has two positions EXT and INT If you intend to use an extemal antenna make sure the switch is in the EXT position For use with the intemal antenna put the switch in the INT position 3 Output Switch This switch has two positions 90 and Line For direct connection of the WFM 1 to speakers put the switch in the 80 position For use with an extemal power amplifier put the switch in the Line Position 4 Level Knob The LEVEL knob is used to contro the listening volume of the WFM 1 5 Power Button and LED When the WFM 1 is on button in the in position the LED will glow red 6 Tuning Knob and LED This knob is used to select FM radio signals When a signal is tuned properly the LED will glow 7 Antenna This is the internal antenna the WFM 1 uses to receive radio signals It telescopes to a length of 35 8 Power Supply Plug Use only a 16 16 5 volt AC 1000 mA adaptor Peavey part 70900660 How To Use the WFM 1 1 Mount the WF
5. tal Harmonic Distortion 3 THD 3 5W 5 THD 3 0W Output Level 18 dBm across 6002 Hum and Noise 80 dB below rated power Output Impedance Bohms 600 ohms Power Consumption 7 5W 16 VAC Wall Mount Transformer Dimensions 59 wide 2 high 3 deep Radio Section FM Broadcast Band Sensitivity Signal Handling Signal to Noise Ratio Total Harmonic Distortion AM Suppression Selectivity 88 108 MHz 15 uV for 3 dB limiting 200 mV 60 dB 7 at 22 5 kHz deviation 50 dB 5 300 Hz 35 dB _scoonon zangua amr excess or rut anoue penumsiate coan p 34 Gore sad be ialen so mat oneris de vat lat ans e a LIMITED WARRANTY Peavey Electronics Corporation warrants to the original purchaser of this new Architectural Acoustics product that it is free from defects in material and workmanship If within one 1 year from date of purchase a properly installed product proves to be defective and Peavey is notified Peavey will repair or replace it at no charge Note Batteries and patch cords not covered Original purchaser means the customer for whom the product is originally installed Damage resulting from improper installation interconnection of a unit or system of another manufacturer accident or unreasonable use neglect or any other cause not arising from defects in material and workmanship is not covered by this warranty The warrant
6. y is valid only as to products purchased and installed in the United States THIS LIMITED WARRANTY IS IN LIEU OF ANY AND ALL WARRANTIES EXPRESSED OR IMPLIED INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR USE UNDER NO CIRCUMSTANCES WILL PEAVEY BE LIABLE FOR ANY LOST PROFITS LOST SAVINGS INCIDENTAL DAMAGES OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE PRODUCT EVEN IF PEAVEY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE THIS LIMITED WARRANTY IS THE ONLY EXPRESSED WARRANTY ON THIS PRODUCT AND NO OTHER STATEMENT REPRESENTATION WARRANTY OR AGREEMENT BY ANY PERSON SHALL BE VALID OR BINDING UPON PEAVEY Peavey s liability to the original purchaser for damages for any cause whatsoever and regardless of the form of action is limited to the actual damages up to the greater of Five Hundred Dollars 500 or an amount equal to the purchase price of the product that caused the damage or that is the subject of or is directly related to the cause of action This limitation of liability will not apply to claims for personal injury or damage to real property or tangible personal property allegedly caused by Peavey s negligence For information on service under this warranty call a Peavey customer service representative at 601 483 5976 ARCHITECTURAL ACOUSTICS Features and specifications subject to change without notice Division of Peavey Electronics Corporation 711
Download Pdf Manuals
Related Search