Lightolier IS:40825 User's Manual
Contents
1. CROSS BAR OUTLET BOX SCREW PROVIDED WITH OUTLET BOX 4 Position BACKPLATE over CROSSBAR allowing CROSSBAR MOUNTING SCREWS to come through holes in BACKPLATE ASSEMBLY CAUTION MAKE CERTAIN WIRES ARE NOT PINCHED BETWEEN PARTS 5 Secure BACKPLATE ASSEMBLY in position by installing two BATTERY NUTS over CROSSBAR MOUNTING SCREWS and tighten 6 Install recommended lamp s CAUTION MAXIMUM WATTAGE AS MARKED ON FIXTURE MUST NOT BE EXCEEDED DIFFUSER INSTALLATION 1 Slide DIFFUSER down into NOTCHES in BACKPLATE ASSEM BLY until DIFFUSER rests in slot in support arm Secure DIFFUSER in position by tightening four DIFFUSER MOUNTING SCREWS through holes in BACKPLATE ASSEM BLY against DIFFUSER Caution Diffuser damage may occur do not over tighten diffuser mounting screws LIGHTOLIER WARNING PUSH SUPPLY LEADS SECURELY INTO JUNCTION BOX BEFORE PERMANENT MOUNTING WARNING FOR SUPPLY CONNECTIONS USE WIRE RATED FOR AT LEAST 90 C WARNING RISK OF FIRE MOST DWELLINGS BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED 60 C CONSULT A QUALIFIED ELECTRICIAN BEFORE INSTALLING Ca oe DIFFUSER BACKPLATE ASSEMBLY DIFFUSER MOUNTING SCREW e BATTERY NUT SUPPORT ARM FIG 1 LIGHTOLIER a GENLYTE company 631 Airport Road Fall River MA 027202. READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE This fixture is intended for installation in accordance with the National Electrical Code and local regulations To assure full compliance with local codes and regulations check with your local electrical inspector before installation To prevent electrical shock turn off electricity at fuse box before proceeding Retain these instructions for maintenance reference 0998 INSTRUCTION SHEET NO 1S 40825 Page 1 of 1 INSTRUCTION SHEET FOR INSTALLATION OF BOWSHIELD ADA WALL BRACKET SERIES NOTE This instruction sheet covers several fixture styles Backplate lamp type and diffuser assembly may vary slightly from that shown although installa tion is the same BACKPLATE INSTALLATION Thread CROSSBAR MOUNTING SCREWS into CROSSBAR as shown Fig 1 Using appropriate slots in CROSSBAR secure CROSSBAR to OUTLET BOX using OUTLET BOX SCREWS provided with OUTLET BOX While supporting BACKPLATE ASSEMBLY make connections black fixture lead or fixture lead without tracer marks to hot black supply lead white fixture lead or fixture lead with trac er marks to neutral white supply lead Uninsulated fixture wire is a ground wire and must be connected to grounding ter minal or ground lead inside OUTLET BOX Use WIRE NUTS local hardware item Push supply wires and connections back into OUTLET BOX GROUND wine OUTLET BOX CROSS BAR MOUNTING SCREW
Download Pdf Manuals
Related Search