Kompernass KH 2255 User's Manual
Contents
1. Komperna GmbH Burgstrasse 21 D 44867 Bochum www kompernass com ID No KH 2255 09 06 V1 KH2255_IB_UK 13 02 2007 14 57 Uhr N Music Play ame 1 CD Clock Radio KH 2255 Operating instructions KH2255 IB UK 13 02 2007 e bench KH 2255 14 57 Uhr nn 900 KH2255_IB_UK 13 02 2007 14 57 Uhr CD Clock Radio Safety information 4 Delivery Contents 5 Intended Usage 5 Technical Data 5 Operating elements 6 Commissioning 6 Battery Back up System in Case of Power Failures 6 Setting the Time 7 Radio operation 7 Use of the CD Player 7 Further Functions of the CD Player 8 Setting the Alarm Time and Alarm Type 8 Sleep timer 9 Cleaning 10 Disposal 10 Warranty amp customer service 10 Read the operating instructions carefully before using the appliance for the first time and preserve this booklet for later reference Pass the manual on to whom soever might acquire the appliance at a later date en KH2255 IB UK 13 02 2007 14 57 Uhr oe CD Clock Radio Safety information A gt gt Important This clock radio employs a laser beam In order to avoid any risk of injury or accident due to this laser beam the appliance may only be opened by qualified specialists The appliances complies with the international safety regulations and the Directives of the Eur2. station using the TUNING knob 7 To switch off the radio press the button ON OFF The indicator light ON OFF goes out Use of the CD Player 1 Open the CD compartment by hand and insert the CD with the label facing to the rear into the CD compartment and close the CD compartment 2 Push the function selector switch to position CD 3 When the ON OFF button is pres sed the total number of CD tracks appears on the display After a few seconds the time is displayed again 4 Press the button PLAY PAUSE to start the playback of the first track 01 appears first on the display followed shortly thereafter by the time again Push the band selector switch to position FM UKW or AM MW In order to achieve optimum recep tion extend the FM antenna to its full length For the AM waveband the appliance needs to be turned to achieve optimum reception Switch on the appliance with the ON OFF button The indicator light 9 comes on when the appliance is switched on The volume display and frequency display AD light up Use the button PLAY PAUSE also to briefly interrupt the playing of a track The playback can be resumed by pressing button PLAY PAUSE again 5 Set the desired volume with the volume controller 9 6 The playback can be stopped by pressing button STOP KH2255_IB_UK 13 02 2007 14 57 Uhr nn Further Functions of the CD Pla
3. D compartment and close the CD compartment 2 Push the function selector switch to position CD The total playing time of the CD player in Alarm mode is 60 minutes If no CD is inserted and alarm mode CD player is set the alarm signal of the setting BUZZER sounds automa tically KH2255 IB UK 13 02 2007 14 57 Uhr nn Switching OFF the alarm The alarm time is programmed for 60 minutes gt SNOOZE Press the button SNOOZE to switch off the alarm temporarily The alarm will then sound again after roughly 6 minutes gt ON OFF Press button ON OFF The alarm is switched off but will sound again after 24 hours gt ALARM I ALARM II Press the ALARM ALARM II button to switch off the alarm permanently Sleep timer gt Move the function selector switch to position CD or TUNER gt When you press the button SLEEP 90 appears on the display gt Press the button SLEEP again to set the desired sleep time 90 60 30 or 15 minutes This starts after a few seconds gt To stop the playback earlier press the button ON OFF If the playing time of the CD is shor ter than the sleep time set by you the music ends as soon as all the tracks on the CD have been played KH2255_IB_UK 13 02 2007 14 57 Uhr e Cleaning Wipe the appliance with a damp cloth Do not use aggressive or chemical clea ning agents These would result in damage to the appliance Di
4. ery is recommended In order to ensure optimum functioning the battery should be changed every 6 months Batteries are not charged in the battery compartment Battery Back up System in Case of Power Failures The batteries ensure that the clock conti nues to function even in the event of a power failure In order to prolong the battery life however the time is not shown on the display If no battery has been inserted 12 00 appears on the dis play This means that you have to carry out the time and alarm settings again KH2255_IB_UK 13 02 2007 14 57 Uhr nn Setting the Time Setting the time when switching on the first time Hold the button TIME depressed to switch between the 12 hour and 24 hour modes gt The time flashes Set the desired time using the buttons MINUTE and HOUR gt As soon as you press the button TIME the setting is saved The displayed time no longer flashes Setting the time at some later point Hold the button TIME depressed to switch between the 12 hour and 24 hour modes gt Press the button TIME D The time flashes Set the desired time using the buttons MINUTE and HOUR gt As soon as you press the button TIME again the setting is saved The displayed time no longer flashes Radio operation 1 Push the function selector switch to position TUNER 5 Set the desired volume with the volume controller 9 6 Select the desired radio
5. opean Community It also complies with the currently applicable standards on electrical safety and electro magnetic compatibility EMC Caution In order to avoid the risk of electric shock the cover of the appliance must not be removed There are no parts that can be serviced inside the appliance Always contact qualified specialists in the event of problems or faults This symbol warns the user of hazardous voltages inside the appliance This symbol is intended as a warning that personal injury can occur if the information given in the operating instructions for the device is not strictly observed A Danger Laser Beams The appliance is fitted with a Class 1 Laser Never open the device Never attempt to repair the device There is invisible laser radiation inside the device Avoid all direct optical contact with the laser beam it could lead to serious eye injuries A Warning In order to avoid the risks of fire and electric shock the appliance must not be exposed to rain or moisture The ventilation openings must not be blocked or covered Important Do not throw batteries into the fire Do not immerse the device in water and avoid splashes and droplets of water entering the appliance Do not place any water filled vessels such as e g flower vases on the appliance Electrical Fast Transient Burst Remark In case of misfunction due to electrical fast transient Burst just reset the prod
6. sposal 5 Do not dispose of the device in m Normal domestic waste Dispose of the device over a registered waste disposal firm or through your com munal waste disposal facility Observe the currently valid regulations In case of doubt consult your waste disposal facility Battery disposal Batteries may not be disposed of with normal domestic waste All consumers are statutorily obliged to dispose of batteries at the collection point in their community district or with the original supplier The purpose of this obligation is to ensure that batteries can be dispo sed of in an environmentally friendly manner Only dispose of batteries when they are fully discharged Warranty amp customer service The warranty conditions and the service address can be found on the warranty card Komperna GmbH Burgstrasse 21 D 44867 Bochum www kompernass com
7. ss the button STOP D to stop the playback If you wish to repeat the programming later 1 Press the button PROGRAM 9 again to activate the programming The in dicator light PROGRAM lights up 2 Press the button PLAY PAUSE to play the programmed tracks gt To cancel the programming open the CD compartment Setting the Alarm Time and Alarm Type With this appliance you can set two different wake up times that can be used individually or simultaneously e AL1orAL2 e or AL1andAL2 Setting the alarm time e Alarm AL 1 Press the button ALARM Press the buttons Minute D and Hour to set the desired alarm time The wake up time is stored as soon as you press the button ALARM The indicator for Alarm appears on the display If you wish to switch off the alarm press the button ALARM ern e Alarm AL 2 Press the button ALARM II and carry out the same steps as described above The indicator for Alarm II appears on the display gt Now select the wake up mode using the function selector switch CD TUNER or BUZZER e Alarm mode BUZZER Move the func tion selector switch to the BUZZER position e Alarm mode Radio gt Carry out the steps 1 to 7 described under Radio operation to tune the radio to your desired station for the radio alarm e Alarm mode CD player 1 Open the CD compartment and insert the CD with the label facing to the rear into the C
8. uct reconnect of power source may be required to resume normal operation ESD Remark In case of misfunction due to electrostatic discharge just reset the product reconnect of power source may be required to resume normal operation A case of electrostatic discharge occurs for example should someone wearing shoes with plastic soles walk over a carpet that also contains plastic elements Through the friction of the shoe soles on the carpet a charge is created in the body which discharges itself as soon as one touches an electricity conducting object such as for example a door knob or the bodywork of a motor vehicle Direct contact is not required to effect a discharge It is sufficient to approach the conducting item to within a few centimetres The charge can the dis charge itself over an electric arc A discharge is thus also possible through plastic housing components KH2255_IB_UK 13 02 2007 14 57 Uhr nn Intended Usage e This device is suitable for the recep tion of radio stations and the playing of audio CDs and is equipped with individually variable alarm functions e Any other use or modification of the appliance is considered improper use and may present significant risks of accidents e The manufacturer accepts no liability for improper use Technical Data Power supply 230 240 V 50 Hz Backup battery 2x 1 5 V Type AA bat tery not included in the scope of supply Deli
9. very Contents CD player Frequency range 3dB 100 Hz to CD Clock Radio 16 kHz Operating Instructions Laser A 760 nm Warranty card Pmax 0 4 mW Radio FM 87 5 108 MHz AM MW 530 1600 kHz KH2255_IB_UK 13 02 2007 14 57 Uhr nn Operating elements Commissioning Button STOP TIME CD compartment Button Skip Fast Search forwards gt bI Hour Button PLAY MODE Indicator light Repeat Buttons ALARM I and ALARM II Indicator light Sleep Button SLEEP Indicator light Random Button SNOOZE Tuning display Volume display Button ON OFF Indicator light ON OFF Indicator light Program Button PROGRAM Preprogramming of CD titles Button Skip Fast Search backwards M4 Minute Button PLAY PAUSE Start of the CD playback or brief interruption in the CD playback Volume controller Tuning knob for selecting the radio station Band selector switch AM MW FM Function selector switch CD TUNER BUZZER FM antenna OBOOOGGSSOLOOOO OOO This CD clock radio is operated with 230 240 Volt alternating current AC 50 Hz It is additionally equipped with a back up system for the event of power failures for which two 1 5 V block batte ries not included in the scope of supply have to be inserted gt Insert the plug of the power lead into a suitable plug socket AC voltage Place the batteries into the battery compartment on the underside of the appliance gt The use of an alkaline batt
10. yer M4 SKIP FAST SEARCH Dbl gt Press bbl G to skip to the next track or press button G several times to skip several tracks Press to jump to the start of a track or press button 44 several times to go back several tracks If M4 or WI Q are held de pressed certain points of a track can be found quickly REPEAT Repeat playback RANDOM 9 Random playback gt Press the button Play Mode once to repeat the playback of a particular track The REPEAT display flashes gt Press the button Play Mode once again to repeat the playback of the whole CD The REPEAT display lights up gt Pressing button Play Mode again cancels this function The REPEAT display goes out gt The indicator light RANDOM lights up The CD tracks are played in random order gt Pressing button Play Mode again cancels this function The indicator light RANDOM goes out PROGRAM 6 For preprogramming tracks in any order 1 Insert the CD 2 Press button ON OFF 3 The total number of tracks appears briefly on the display Pressing the button PROGRAM again displays The indicator light PROGRAM flashes 4 Select your track with the buttons Skip Fast Search Then press the button PROGRAM 6 to save the track Proceed as described above to program further tracks A total of 20 tracks can be programmed Press the button PLAY PAUSE to start the playback Pre
Download Pdf Manuals
Related Search