HP 5Si-8000 User's Manual
Contents
1. printer J 800 551 1943 HP LaserJet 5Si 8000 Series Maintenance Kit Instructions Page 1 LJ 5Si 8000 Series Maintenance Kit Includes 1 HP RG5 4447 HP Fuser 8 HP RF5 1834 Feed Separation Rollers 1 HP RF5 1412 Transfer Roller WARNING Turn the printer off unplug it and allow it to sit for 30 minutes before performing maintenance procedures Fuser Removal 1 Open the left side door If duplex unit is installed remove it by pushing down on the green release lever and pulling it towards you and out of the printer 2 Locate the fuser s left and right blue locking levers Turn each one downwards 90 degrees to unlock the fuser 3 Grab the handles on the far left and right side of the fuser Lift up slightly and pull it towards you until it is out of the printer Fuser Installation 1 With the blue locking levers facing downward slide the new fuser into the printer and drop it into place 2 Turn the blue locking levers upward 90 degrees until they snap into place 3 Reinstall the duplex unit if it was removed in step 1 Feed Separation Roller Removal amp Replacement Ei Ei E x ey ey ay 3 1 Pull tray 2 open until it stops 2 Lift the front of the tray up and pull it towards you It may be necessary to shake it slightly to release the tray from the printer Do the same with tray 3 3 Locate the four feed separation rollers with the blue hub inside the printer Two for tray 2 and two for tray 3 Pinch the t2. OFF press the SELECT button so that appears If SERVICE MESSAGE ON press the button to change ON to OFF then press the SELECT button so that appears 7 Press the ONLINE or GO button OonrkWN
3. abs together and pull the rollers off of the shafts 4 Remove the four new feed separation rollers from the bag Install the new rollers by sliding them onto each shaft until they snap into place It may be necessary to turn them while doing this printerG T ECO 800 551 1943 HP LaserJet 5Si 8000 Series Maintenance Kit Instructions Page 2 Transfer Roller Removal amp Replacement Use The Latex Gloves When Replacing The Transfer Roller 1 Open the top cover and remove the toner cartridge 2 Locate the blue gear on the far left side of the transfer roller Gently lift up on this gear until it is free from the retainer clip 3 Slide the transfer roller to the left and remove it from the printer 4 Install the right side shaft of the new transfer roller then snap the left side down into the retainer clip 5 Press down on both sides of the silver and black transfer roller guide until it snaps into place 6 Replace the toner cartridge close the top cover and plug the printer in Clearing The PERFORM USER MAINTENANCE Message If Displayed Turn the printer on and wait until PERFORM USER MAINTENANCE is displayed Press the ONLINE or GO button so that its green indicator goes off and OFFLINE is displayed Press the MENU button until CONFIGURATION MENU is displayed Press the ITEM button once so that SERVICE MESSAGE ON or SERVICE MESSAGE OFF is displayed If SERVICE MESSAGE
Download Pdf Manuals
Related Search