Haier Refrigerator HRZ-113 User's Manual
Contents
1. of the appliance unless they are of the type recommended by the manufacturer Water contained in food or airinside the refrigerator may form a layer of frost This frost will damage the refrigerator Defrost the refrigerator if the frost is more than 2mm thick Do not use a sharp tool to scrape off ice and frost or to separate food which has become stuck so as not to damage the evaporator If the supply cordis damaged it must be replaced by the manufacturer its service agent or similarly qualified person in order to avoid hazard IMPORTANT DISPOSAL INSTRUCTIONS As aresponsible retailer we care about the environment As such we urge you to follow the correct disposal procedure for your product and packaging materials This will help conserve natural resourses and ensure that it is recycled in a manner that protects health and the environment You must dispose of this product and its packaging according to local laws and regulations Because this product contains electronic components and sometimes batteries the product and its accessories must be disposed of separately from household waste when the product reaches its end of life Contact your local authority to learn about disposal and recycling The product should be taken to your local collection point for recycling Some collection points accept free of charge We apologise for any inconvenice caused by minor inconsistencies in these instructions which may occur as a resul2. the lower hinge 2 and then remove the hinges 2 5 Remove the left front leg 4 and transfer itto the right side Remove the hole cover plate 7 to the right side Before placing this lower hinge 2 remove the bolt pin 9 and reverse the direction of the lower hinge 2 Then install the lower hinge 2 onto the left side of the lower frame with two screws 8 8 Insert the bolt pin 9 to the lower hinge 2 9 Lift the door into place Ensure the door is level with the bottom foot 10 Hold the door inthe closed position and secure the top hinges 5 to the top frame of the left side with the two screws 1 Do not over tighten the two screws Only tighten until the top of the dooris level with the counter top 11 Install the upper hinge cover 6 onthe upper hinge LA N O FIGURE 1 FIGURE 2 FIGURE 1 REPRESENTS POSITION OF COMPONENTS PRIOR TO DOOR REVERSAL FIGURE 2 REPRESENTS POSITION OF COMPONENTS AFTER DOOR REVERSAL Replacing bulbs When replacing the bulb unplug the appliance from the mains proceed as follows Thermostat 1 Remove the water drip tray 2 Hold the lamp cover and push toward inside of the cabinet Lamp cover 3 Remove the lamp cover A Unscrew the bulb and screw in a new 10W bulb 5 Hold the lamp cover and put the hook of the lamp cover to click into the thermostat box 6 Pull thelamp cover forward to click into the thermostat box 7
3. Haler HRZ 113 REFRIGERATOR USER INSTRUCTIONS PARTS AND FEATURES O D E 4 6 Far fey E A 38000 a Cabinet Drip Tray Shelf Glass Cover Compressor back Crisper Bin Leveling Feet Bottle Racks Recessed Handle Door Switch Temperature Control Knob Small Refrigerator Compartment Clearance space required for ventilation Ventilationis required around the refrigerator to help with the dissipation of heat operation at maximum efficiency and atlower power consumption The recommended clearance space should be at least 100mm for all sides and 200mm from the top Power Supply The refrigeratoris designed to only operate ona power supply of 220 240 volts 50 hertz Please make sure it is connected to a power point with the correct earthed three point socket Power Cord The power cord should not be lengthened or folded while in operation Please make sure that the cord is accessible and any excess cord is kept close tothe compressor at the back of the refrigerator Make sure thatthe power cord isn t damaged before plugging into power socket Protection from Moisture Avoid placing the refrigerator in places where heavy moistureis present This isto minimise the possibility of rustto any metal parts Protection from Heat The refrigerator should not be placed near any kind of heat source orin direct sunlight Stable positioning Please ensure that the refriger
4. Replace the drip tray The refrigerator should be cleaned and maintained once a month The power plug should always be disconnected from the power outlet before any cleaning or maintainance is carried out For cleaning do not use hot water petrol alcohol kerosene washing powder cleanser alkaline detergent acid or chemical cloths Never directly spray the refrigerator with water This could cause rust or weaken the insulation Wipe the inner outer and accessories ofthe refrigerator only with luke warm water Forheavier cleaning use asmall amount of washing detergent in luke warm water then wipe down with water and dry with a clean cloth Make sure that the rubber seals on the door are clean and not damaged Avoid leaving oils and solubles on the plastic parts of the refrigerator Try towipe up as it could cause a stain Not doing so could easily age the plastic Bad odours can also occur if notcleaned regularly 1 When the refrigerator does not work Check ifthere is a power failure Check ifthe power plug is plugged into the power outlet Check ifthe fuse has blown 2 When the refrigerator is cooling excessively The temperature control dial may be set too high 3 When the refrigeratoris not cooling sufficiently Hot food may have just been placed inside allow it to cool down There istoo much food inthe refrigerator The door may nothave been closed properly The door gasket seals may be damaged The refrigerato
5. ator is placed on aflat solid floor It should not be placed on any soft surface If the refrigerator is not on astable surface adjust the feet Keep Away from Danger Do notplace the refrigerator near combustible or flammable substances such as gas petrol alcohol lacquer or oils Moving When moving or relocating the refrigerator avoid having the refrigerator tilt more than 45 degrees At no point should the refrigerator be turned upside down The thermostat automatically adjusts the temperature inside the refrigerator The thermostat knob can be turned from position1 to 5 5 being the coldest setting When set to O the appliance is switched off To store food for a short period of time set the thermostat between 1 Min and 3 Med To store food for long periods of time set the thermostat to 3 or 4 Note The ambient air temperature frequency of door opening and the position of the appliance can affect internal temperatures These factors must be taken into account when setting the thermostat This refrigerator has been built with the door hinges onthe right If you wish to change the opening direction follow the instructions below 1 Remove the upper hinge cover 6 first 2 Remove the two screws 1 that hold the upper hinge 5 right side to the frame Take away the upper hinge 5 Liftthe door and place it ona padded surface to prevent scratching it 4 Remove the two screws 8 that hold
6. oduct check thatthe tubing of the refrigerant circuithas not been damaged during transportation Leaking refrigerant may cause eye injuries or may ignite Istall the appliance ina roomthat is at least 1m for every 8g of refrigerant The amount of refrigerantin the appliance can be found on the rating plate the back of the unit Keep ventilation openings inthe appliance enclosure or in the built in structure clear of obstruction Do not damage the refrigeration circuit If your are unsure of the refrigerant type check the rating plate on the back of the unit Warnings This appliance is not intended for use by persons including children with reduced physical sensory or mental capabillties or lack of experience and knowladge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance If the supply cord is damaged it must be replaced by the manufacturer its service agent or similarly qualified persons in order to avoid a hazard Keep ventilation openings in the appliance enclosure or in the built in structure clear of obstruction Do not use mechanical devices or other means to accelerate the defrosting process other than those recommended by the manufacturer Do not damage the refrigerant circuit Do not use electrical appliances inside the food storage compartments
7. r may not be well ventilated There maybe Insufficient clearance between the refrigerator and surrounding walls The temperature control dial may notbe set properly 4 While defrosting water overflows the refrigerator and onto the floor Check thatthe drain pipe andthe drain hose are not clogged Check thatthe drain pan is housed properly 5 When condensation forms on the outside ofthe refrigerator Condensation may form onthe outside when the humidity is high such as during awet season This isthe same effect as condensation forming when chilled water is poured intoa glass It does not indicate a failure wipe witha dry cloth 6 When you hear a sound like water flowing A sound like water flowing is the refrigerant flowing It does not indicate a failure 7 When the cabinet s side panel heats up The side panel ofthe cabinet will heatup whenthe dooris opened or closed frequently when starting the unit and when the unit operates insummer with high ambient outside temperature Do nottouch the panel itresults from the dissipation of the heat from inside the cabinet and does not indicate a failure For detailed technical specification please referto the nameplate atthe back ofthe refrigerator Specifications are subjectto change without prior notice R600a Refrigerant This appliance may contain a small quantity ofenvironmentally friendly but flammable non synthetic R600a refrigerant Upon opening and installing your pr
8. t of product improvement and development CKHER D01 C
Download Pdf Manuals
Related Search