GE LGC Installation Guide
Contents
1. GE Lighting Solutions GEH 5869 INSTRUCTIONS Legacy Luminaire READ THOROUGHLY BEFORE INSTALLING A WARNING Risk of electric shock e Turn power off before servicing see instructions GENERAL This luminaire is designed for use in outdoor applications and must adhere to 25 C Max ambient temperature limitation Install and maintain it according to the following recommendations A MOUNTING AX CAUTION Unit will fall if not installed properly e Follow installation instructions 1 Place fixture on appropriately sized tenon 2 Tighten fixture set screws to 18 to 22 ft lbs of torque 3 Remove ballast cannister 4 Wire unit see section B of instruction sheet for wiring instructions 5 Replace ballast cannister 6 Install Lamp see section C of instruction sheet for lamp instructions 7 Install refractor making sure that asymmetric refractors are properly oriented with respect to their house side or street side labeling 8 Tighten globe set screws to lightly contact globe B WIRING Make all electrical connections in accordance with the National Electrical Code and any applicable local code requirements Verify that supply voltage is correct by comparing it to nameplate IF SINGLE VOLTAGE All single voltage ballasts are pre wired such that user need only connect the supply conductors IF MULTIVOLT 120 208 240 277 volts Connect t2. he ballast lead with the insulated terminal to the desired voltage terminal as indicated on the ballast terminal nameplate IF MULTIWATT Multiwatt ballasts are available in various combinations of wattage See wiring instructions on wiring tag inside the luminaire e Optional Features such as photocontrols are voltage specific e When changing voltage on reconnectable units move only the lead with the insulated connector C LAMPS AY CAUTION Risk of burn e Allow lamp fixture to cool before handling Use only lamps specified on nameplate Observe lamp manufacturer s recommendations and restrictions on lamp operation particularly ballast type burning position etc LAMP TIGHTNESS The lamp should be securely inserted to NEMA EEI specified torque of 35 inch pounds which is best achieved by very firmly tightening to insure application of sufficient torque Tightening must be sufficient to fully depress and load center contact of socket NOTE Use of lubricants on lamp base or sockets can cause rapid lamp failure and voids fixture warranty D MAINTENANCE AND CLEANING It will occasionally be necessary to clean the refractor to maintain light levels Frequency of cleaning will depend on ambient dirt level and minimum light level which is acceptable to the user The refractor should be washed in a solution of warm water and mild nonabrasive household detergent rinsed with clean water and wiped d
3. ighting Solutions Information provided is subject to change without notice All values are design or typical values when measured under laboratory conditions 35 201578 7R 08 01
4. ry The light output of a luminaire is dependent on the age of the lamp In applications where the light level is critical it may be desirable to replace lamps before they burn out The lamp manufacturer can provide data showing how the lamp light output decreases with use GLOBE SET SCREWS Tighten to lightly contact globe Mount with Photo control aimed away from other light sources Available only with Capital Style E MOUNTING SET SCREWS Tighten to 18 to 22 foot pounds torque TYPE Ill LENS optional Install before lamp Align for desired distribution and secure with supplied clamp SOCKET Mogul base lamps should be tightened to 35 inch pounds torque BALLAST CANISTER For multivolt ballasts see instructions above These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation operation or maintenance Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser s purposes the matter should be referred to GE Lighting Solutions GE Lighting Solutions e 1 888 MY GE LED e www gelightingsolutions com 1 888 69 43 533 GE Lighting Solutions is a subsidiary of the General Electric Company Evolve and other trademarks belong to GE Lighting Solutions The GE brand and logo are trademarks of the General Electric Company 2011 GE L
Download Pdf Manuals
Related Search