Friedrich PDXRC User's Manual
Contents
1. COntaINS cece Qty 1 Installation instructions 1 2 Remote control ccccceeeeeees 1 3 AAA batterieS cece eeee 2 4 Fill piece 2 0 0 eceeeeeeeeeeeeees 1 5 Screws 8 X 3 8 cceeecceeeeeeeeees 2 Remote Control Operation POWER Press the Power button once The unit will automat ically turn on in the mode and fan speed it was last left on To set mode of operation COOL Press the Cool button to automatically switch the operating mode to COOL HEAT Press the Heat button to automatically switch the operating mode to Heat FAN ONLY Press the Fan Only button if you want to run the fan only COOLER Press the Cooler button to raise the tempera ture setting one degree WARMER Press the Warmer button to lower the tem perature setting one degree To adjust fan speed Low Fan Press the Low Fan button to adjust the fan speed to low High Fan Press the High Fan button to adjust the fan speed to high Fill Piece Installation Operating Range The hand held remote has an operating range of up to 25 feet The infrared remote control signal must have a clear path to transmit the command to the PTAC unit The remote signal has some ability to bounce off of walls and furniture similar to a television remote control The diagram below shows t2. he typical operating range of the control in a standard room with 8 ft high ceilings PTAC located in the center of wall PTAC located with wall to the left 25 7 WALL x Da 7 pe N 18 to36 wi z PTAC located with wall to the right N 25 WALL 25 gt 3a 18 to36 920 172 00 10 07
3. rriedrich Model PDXRC Operating Instructions HAND HELD REMOTE CONTROL For Use With Packaged Terminal Units Please read these instructions completely before attempting installation NOTE This kit is for use with PD model Friedrich PTAC units with SD or later suffixes For example PDEO9K3SD This kit will not work with prior models Preparing unit for remote control use NOTE The remote control operation requires the control panel door of the PTAC to remain open or be removed from the unit If electing to use the fill piece follow Steps 1 4 Otherwise proceed straight to Step 5 1 Remove the control panel door from the front grille by unhinging it from the grille This is done by pushing back on the top portion of the door until the door is released from the hinges 2 Remove the front grille from the unit 3 Screw the fill piece to the unit using the screws provid ed into the two screw holes above the control panel 4 Reattach the front grille 5 Turn on the PTAC unit 6 Put batteries in the remote 7 The remote control is now ready for operation 8 Your unit should come already enabled to receive the remote signal If after all the steps are done and your unit does not respond to remote signal hold the temp v and the temp buttons simultaneously for three seconds or until the display window shows E to enable the remote PDXRC Remote Control 920 172 00 2 08 This kit
Download Pdf Manuals
Related Search