Directed Video WHS208 User's Manual
Contents
1. Use cau tion do not drill through the roof of the vehicle Locate a roof metal beam or glue a piece of wood to the metal roof 4 Reinstall the plastic caps 2 Channel Wireless Headphones Follow the instuctions with the owner s manual for the headphones for prop er operation Figure 1 Transmitter Mounting Diagram TRANSMITTER POSITION IN MIDDLE OF SEATING AREA 2005 Directed Electronics all rights reserved WHS208 TWO CHANNEL AUTOMOTIVE WIRELESS HEADPHONE SYSTEM Figure 1 Transmitter Mounting Diagram continued Figure 2 Wiring Harnesses WIRING DIAGRAM le 1 LEFT RCA CHANNEL IN 1 GROUND J 2 RIGHT RCA CHANNEL IN lt 3 DC 12V GND NEGATIVE 4 DC 12V IN POSITIVE M l 1 LEFT RCA CHANNEL IN J CHANNEL B 2 RIGHT RCA CHANNEL IN Figure 3 IR Transmitter CEILING OF THE CAR ALWAYS FACE LEDs TOWARDS REAR OF VEHICLE O O a FACE LEDs TOWARDS REAR OF VEHICLE CAPS 2 pcs SIDE VIEW TOP VIEW N88408 10 052. LDixected VIDEO Parts Supplied One IR Transmitter Two IR Transmitter Harness Two IR 2 Channel Headphones Important Notes For best results the IR transmitter must be installed as shown in figure 1 with the LEDs pointing towards the rear of the vehicle Audio input can be connected to either a low level fixed audio output or a variable level audio output such as a speaker or headphone output If it is connected to a low level output only the volume control on the headphones needs to be adjusted to control volume level If connected to a variable level outputs then the volume adjustment needs to be accomplished at both the sources and at the headphones Wire Harness with RCA connectors 1 Using two dual RCA M M cables not supplied length to be determined by installation requirements connect one end of each to the Red and White RCA jacks Connect the other ends to the channel A and channel B to each of the low level signal sources A and B 2 Connect pin 4 of the channel A harnness Black wire negative to the ground of the vehicle 3 Connect pin 5 of the channel A harness Red wire 12 volt to the igni tion source This is an ignition wire that provides 12V when the ignition key is turned on IR Transmitter 1 Plug wire harness into transmitter 2 Remove the 2 plastic caps on the transmitter to exposed the mounting screw holes figure 3 3 Fasten transmitter to headliner using two short metal screws
Download Pdf Manuals
Related Search