Craftsman 11390 Operator's Manual
Contents
1. SAVE THESE INSTRUCTIONS OPERATION BATTERY PACK CHARGER The battery pack and charger are not included with your worklight They are both sold separately When purchasing use the following information MODELNO BATTERYPACK CHARGER 973 113900 Item No 9 11378 Item No 9 11379 1323509 1426101 BATTERY PACK The battery pack for your worklight has been shipped in a low charge condition to prevent possible prob lems Therefore you should charge it overnight prior to use Note Batteries will not reach full charge the first time they are charged Allow several cycles operating worklight followed by recharging for batteries to become fully charged CHARGING BATTERY PACK See Figure 1 E Charge battery pack only with the recommended charger E Make sure power supply is normal household voltage 120 volts 60 Hz AC only E Connect charger to power supply Mm Place battery pack in charging stand Align raised rib on battery pack with groove in charging stand See Figure 1 E Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charging stand E The charge indicator light LED located on the charging stand will light up red and glow when the charger is properly connected to power supply This light indicates the charger is operating properly It will remain on until battery pack is BATTERY PACK SHOWN IN CHARGING STAND RED LIGHT CHARGING STAND removed from cha2. REMOVE BATTERY PACK See Figure 2 E Use only the recommended battery pack with your worklight WARNING Do not install battery pack to your worklight until you have read and understood all precautions and operating instructions in the manual and printed on battery pack and charger E Orient battery pack so that raised rib on battery pack aligns with groove inside worklight Battery pack is designed to fit only one way in worklight handle E Insert battery pack making sure latches on each side of battery pack snap into place and battery pack is secure in worklight before use A CAUTION When placing battery pack in your worklight be sure raised rib on battery pack aligns with groove inside worklight handle and latches snap into place properly Improper assembly of battery pack can cause damage to internal components mM To remove battery pack locate latches on end of battery pack and depress to release battery pack from your worklight BATTERY DEPRESS LATCHES TO RELEASE BATTERY PACK Fig 2 SWITCH See Figure 3 To turn your worklight on and off depress switch trigger MULTI POSITION HEAD See Figure 3 Your worklight has the feature of a multi position head Rotate head to the desired position as shown in the arrows in Figure 3 MULTI POSITION EAD x SWITCH TRIGGER Fig 3 MAINTENANCE A WARNING When servicing use only identical Craftsman replacement parts Use of any other pa
3. when disconnecting charger E Anextension cord should not be used unless absolutely necessary Use of improper extension cord could result in a risk of fire and electric shock If extension cord must be used make sure a That pins on plug of extension cord are the same number size and shape as those of plug on charger b That extension cord is properly wired and in good electrical condition and c That wire size is large enough for AC ampere rating of charger as specified below Cord Length Feet 25 50 100 Cord Size AWG 16 16 16 Note AWG American Wire Gage DO NOT OPERATE CHARGER WITH A DAMAGED CORD OR PLUG If damaged have replaced immediately by a qualified serviceman E Do not operate charger if it has received a sharp blow been dropped or otherwise damaged in any way take it to a qualified serviceman E Do not disassemble charger take it to a qualified serviceman when service or repair is required Incorrect reassembly may result in a risk of electric shock or fire E To reduce the risk of electric shock unplug charger from outlet before attempting any maintenance or cleaning Turning off controls will not reduce this risk Do not use charger in wet or damp conditions Disconnect charger from power supply when not in use SAVE THESE INSTRUCTIONS Review them frequently and use them to instruct others who may use this light If you loan someone this light loan them these instructions also
4. GHT IN A CHECK DAMAGED PARTS Before further use DAMP OR WET LOCATION DO NOT STORE IN LOCATIONS WHERE THE TEMPERATURE IS LESS THAN 50 F OR MORE THAN 100 F Do not store in outside sheds or in vehicles of this worklight a part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function Do not use worklight if it does not function properly RULES FOR SAFE OPERATION Continued SAFETY RULES FOR WORKLIGHTS A WARNING Do not operate worklight or charger near flammable liquids or in gaseous or explosive atmospheres Internal sparks may ignite fumes A WARNING Lens and bulb become hot during use During or immediately after use don t lay worklight flat on lens surface or place lens area in contact with a plastic or fabric covered surface Handle worklight with care around any flammable surface Let worklight cool for several minutes after use before changing bulb Do not use or permit use of worklight in bed or sleeping bags This worklight lens can melt fabric and a burn injury could result IMPORTANT SAFETY RULES FOR BATTERY TOOLS E USE ONLY THE CHARGER RECOMMENDED FOR USE WITH YOUR WORKLIGHT Do not substitute any other charger Use of another charger could cause batteries to explode causing possible serious injury E Your battery tool should be charged in a location where the temperature is more than 50 F but less than 100 F m Under extreme u
5. Operator s Manual CRAFTSMAN 18 VOLT CORDLESS WORKLIGHT Model No 973 113900 Use worklight only with recommended Craftsman battery pack and charger both sold separately Save this manual for future reference A CAUTION Read and follow all Safety Rules and Operating Instructions before first use of this product e Safety e Operation Customer Help Line 1 800 932 3188 Maintenance Sears Roebuck and Co 3333 Beverly Rd Hoffman Estates IL 60179 USA Visit the Craftsman web page www sears com 983000 141 8 02 INTRODUCTION A CAUTION Carefully read through this entire operator s manual before using your new worklight Pay close attention to the Rules For Safe Operation Warnings and Cautions Safety performance and dependability have been given top priority in the design of this worklight making it easy to maintain and operate If you use your worklight properly and only for it s intended use you will enjoy years of safe reliable service SAFETY AND INTERNATIONAL SYMBOLS This operator s manual describes safety and international symbols and pictographs that may appear on this product Read the operator s manual for complete safety assembly operating and maintenance and repair information MEANING Do not expose to rain or use in damp locations RULES FOR SAFE OPERATION READ ALL INSTRUCTIONS DO NOT PERMIT CHILDREN TO USE WORKLIGHT UNSUPERVISED It is not a toy E KNOW YOUR WORKLIGHT
6. Read operator s manual carefully Learn its applications and The temperature of the bulb will become hot after limitations as well as the specific potential being on for only a short period of time This hot hazards related to this light temperature can cause burn injury if touched and m USE ONLY RECOMMENDED BATTERY PACK can create sufficient heat to melt some fabrics WITH YOUR WORKLIGHT Any attempt to use A WARNING If wrapped or in contact with another battery pack will cause damage to your fabrics the worklight lens can produce sufficient worklight and could possibly explode cause a fire heat to melt some fabrics To avoid serious or personal injury personal injury never allow the worklight lens to E REMOVE BATTERY PACK FROM come in contact with anything WORKLIGHT BEFORE REPLACING BULB OR E KEEP WORK AREA CLEAN CI PERFORMING ANY ROUTINE MAINTENANCE paras ets ie eee sah Suler areas OR CLEANING E DONOT DISASSEMBLE YOUR WORKLIGHT R E TE ae Se AERA ELE OR ERE Te PATTERY OIL AND GREASE Always use a clean cloth lode Also DO NOT di sh may t when cleaning Never use brake fluids gasoline PAR OTRA SOE E Dose ao ter petroleum based products or any strong solvent battery pack by incinerating Do not incinerate to clean your worklight the battery even if it is severely damaged or completely worn out The battery may explode in W STAY ALERT Watch what you are doing and fire use common sense Do not rush H DO NOT STORE YOUR WORKLI
7. ies Length of service from each charging will depend on the type of work you are doing The batteries in this worklight have been designed to provide maximum trouble free life However like all batteries they will eventually wear out Do not disassemble battery pack and attempt to replace the batteries Handling of these batteries especially when wearing rings and jewelry could result in a serious burn To obtain the longest possible battery life we suggest the following To preserve natural resources please recycle or dispose of batteries properly This product contains nickel cadmium batteries Local state or federal laws may prohibit disposal of nickel cadmium batteries in ordinary trash Consult your local waste authority for information regarding available recycling and or disposal options E Store and charge your batteries in a cool area Temperatures above or below normal room temperature will shorten battery life E Never store batteries in a discharged condition Recharge them immediately after they are discharged All batteries gradually lose their charge The higher the temperature the quicker they lose their charge If you store your worklight for long periods of time without using it recharge the batteries every month or two This practice will prolong battery life BATTERY PACK REMOVAL AND PREPARATION FOR RECYCLING A WARNING Upon removal cover the battery pack s terminals with heavy duty adhesi
8. rging stand or charger is discon nected from power supply E Note If charger does not charge battery pack return battery pack and charger to your nearest Sears Repair Center for electrical check E After normal usage 3 hours or less of charging time is required to fully recharge battery pack Note If battery pack is completely discharged 6 hours or longer of charging time is required to fully recharge battery pack The battery pack will become slightly warm to the touch while charging This is normal and does not indicate a problem E Do not place charger in an area of extreme heat or cold It will work best at normal room tempera ture E When batteries become fully charged unplug charger from power supply and remove the battery pack IMPORTANT INFORMATION FOR RECHARG ING HOT BATTERIES When using your worklight continuously the batteries in your battery pack will become hot You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge Note This situation only occurs when continuous use of your worklight causes the batteries to become hot It does not occur under normal circumstances Refer to CHARGING BATTERY PACK for normal re charging of batteries If the charger does not charge your battery pack under normal circumstances return both the battery pack and charger to your nearest Sears Repair Center for electrical check CHARGER Fig 1 OPERATION TO INSTALL
9. rt may create a hazard or cause product damage A WARNING Do not at any time let brake fluids gasoline petroleum based products penetrating oils etc come in contact with plastic parts They contain chemicals that can damage weaken or destroy plastic BULB REPLACEMENT See Figure 4 When purchasing replacement bulb request recom mended part number 981258 001 See Figure 4 TO REPLACE BULB E Remove battery pack from worklight See Page 5 E Depress button located on top of len cover then pull lens cover to remove E Remove old bulb from spring by twisting bulb in a clockwise direction LENS COVER PULL LENS COVER FORWARD TO REMOVE Do not abuse power tools Abusive practices can damage tool as well as workpiece A WARNING Do not attempt to modify this worklight or create accessories not recommended for use with this worklight Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury E Insert new bulb in spring by twisting bulb in a clockwise direction E Replace lens cover aligning tabs inside lens cover with slots on housing then snap into place E Replace battery pack Note For your convenience your worklight has a bulb storage area to store an extra bulb See Figure 4 BUTTON BULB STORAGE AREA SPRING MAINTENANCE BATTERIES Your worklight s battery pack is equipped with nickel cadmium rechargeable batter
10. sage or temperature conditions battery leakage may occur If liquid comes in contact with your skin wash immediately with soap and water then neutralize with lemon juice or vinegar If liquid gets in your eyes flush them with clean water for at least 10 minutes then seek immediate medical attention A WARNING Batteries vent hydrogen gas and can explode in the presence of a source of ignition such as a pilot light To reduce the risk of serious personal injury never use any cordless product in the presence of open flame An exploded battery can propel debris and chemicals If exposed flush with water immedi ately A WARNING Never use a battery pack that has been damaged or received a sharp blow A damaged battery pack is subject to explosion Properly dispose of a damaged battery pack immediately Failure to heed this warning can result in serious personal injury WHEN SERVICING USE ONLY IDENTICAL CRAFTSMAN REPLACEMENT PARTS IMPORTANT SAFETY INSTRUCTIONS FOR CHARGER E Before using battery charger read all instructions and cautionary markings in this manual on battery charger and product using battery charger A CAUTION To reduce the risk of injury charge only nickel cadmium type rechargeable batteries Other types of batteries may burst causing personal injury and damage E Do not expose to wet or damp conditions E To reduce the risk of damage to charger body and cord pull by charger plug rather than cord
11. ve tape Do not attempt to destroy or disassemble battery pack or remove any of its components Nickel cadmium batteries must be recycled or disposed of properly Also never touch both terminals with metal objects and or body parts as short circuit may result Keep away from children Failure to comply with these warnings could result in fire and or serious injury A WARNING Do not attempt to disassemble the battery pack Fire or injury may result
Download Pdf Manuals
Related Search