Cornelius C-750 User's Manual
Contents
1. IMI CORNELIUS INC f One Cornelius Place 029207 VL j Anoka MN 55303 6234 Telephone 800 238 3600 Facsimile 763 422 3246 INSTALLATION INSTRUCTION WATER TANK SEAL KIT P N 308979000 UNIVERSAL C 750 PRE MIX DISPENSER These Instructions outline installation of the Water Tank Seal Kit P N 308979000 on the Universal C 750 Pre Mix Dispenser INSULATED REFRIGERATION LINE DISPENSER IN D B un en d OIMI Cornelius Inc 1989 2002 November 13 2002 Revision A 185211001 NOTE Only qualified personnel should install this kit 1 Unpack loose shipped parts Make sure all parts are present and in good condition 1 200468012 Sheet Metal Screw Phil Truss Hd No 8 by 3 4 in 2 308981044 Front Cover Plate Table 1 Loose Shipped Parts 3 Back Cover Plate 4 Plug 2 in Permagum Sealer 12 in long Rubatex Insulation 1 8 by 1 2 in 78 in long INSTALLING WATER TANK SEAL KIT IMPORTANT This kit is intended to seal the water tank to prevent leakage from splashing water when moving or transporting the Dispenser T IS NOT INTENDED THAT THE DISPENSER MAY BE LAID ON IT S SIDE WHEN WATER TANK IS FULL OF WATER 1 If Dispenser is in operation place power switch on back of Dispenser in OFF position 2 Remove four screws securing Dispenser top cover then lift cover straight up and off NOTE Front of Dispenser is the side facing the dispensing valves 3 Place RUBATEX INSULATION it2. em NO TAG all the way around outer edges of FRONT COVER PLATE item 2 and BACK COVER PLATE item 3 as shown in illustration FILL ANY GAPS AT BUTT EDGES OF RUBATEX INSULATION WITH SMALL PIECES OF PERMAGUM SEALER item 6 4 Place FRONT COVER PLATE item 2 in position on top of water tank as shown in illustration IT MAY BE NECESSARY TO VERY CAREFULLY REFORM OR REPOSITION INSULATED REFRIGERATION LINE ANGLE TO FIT INTO CUTOUT AREA IN CORNER OF FRONT COVER PLATE 5 Secure back side of front cover plate to agitator motor support plate with four THREAD CUTTING SCREWS item NO TAG 6 Secure rest of front cover plate to plastic motor tank rim with six SHEET METAL SCREWS item 1 DO NOT OVERTIGHTEN SCREWS INTO PLASTIC 7 Place BACK COVER PLATE item 3 in position on top of water tank as shown in illustration 8 Secure front side of back cover plate to agitator motor support plate with four THREAD CUTTING SCREWS item NO TAG 9 Secure rest of back cover plate to plastic water tank rim with five SHEET METAL SCREWS item 1 DO NOT OVERTIGHTEN SCREWS INTO PLASTIC 10 Place PLUG item 4 in agitator motor plate water fill hole 185211001 2 14 15 If installing kit on a four flavor Dispenser install PLUG item 5 in 1 2 inch hole in top of agitator motor plate Fill area between insulated refrigeration line and cutout area in front cover plate with PERMAGUM SEAL ER item 6 Also overlap front cover plate and insulated refrige
3. ration line with permagum sealer to prevent water leak If new Dispenser installation refer to manual provided with Dispenser and complete installation as instructed Install Dispenser top cover and secure with four screws If Dispenser was in operation before start of Kit installation place power switch in ON position 3 185211001
Download Pdf Manuals
Related Search