Coleman CEDAR PASS 9160-908 User's Manual
Contents
1. nits CEDAR PASS DOME Instructions apply to Part Number 9160 908 When You Are Ready To Set Up Your Tent 2 Main Tent Select a level campsite clear of 2 Poles rocks branches and other hard or sharp objects Do not set up your tent under trees 1 Rainfl For best results in windy conditions Paie position the end of tent into the wind Layout amp Positioning of Tent Pole Assembly Layout and position tent with door facing desired direction illus 1 Unzip door Stake down tent corners only using the stake loops illus 2 Keep the floor taut Assemble Frame Poles by interlocking shock corded poles Insert the poles into Pole Sleeves The poles should cross forming an X in the middle of tent illus 1 Assembled poles inserted through pole sleeves illus 1 illus 2 Tent stake through ring POLE ASSEMBLY PARTS Part No 9160 302 Part No 9160 304 Rainfly Part No 9160 306 Connect Frame to Tent nsert one end of main tent pole onto pin of ring and pin system at tent corner illus 3 Go to opposite end of pole and gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole Repeat for second pole illus 4 illus 4 a Tent frame Pa set up r P illus 3 Insert pin into pole end Attach Tent to Frame Using Frame Clips Attach frame clips a2. long the edges of tent to frame poles illus 5 illus 6 Make any adjustments to the tent corner stakes that are needed Attach Rainfly Assemble rainfly pole by interlocking shock corded pole Insert rainfly pole into reinforced pockets located at the center edges of the underside of rainfly illus 7 illus 8 Attach underside of rainfly to the rainfly pole illus 8 Drape rainfly over tent frame pole side down Rainfly pole should point out over door and rear window Connect the four elastic loops with S hooks found at the rainfly corners to the fabric loops near frame clips illus 9 Secure rainfly with attachments located on underside of fly illus 10 Stake out the tent with 2 side guylines illus 10 a illus 5 Frame clips Insert rainfly pole into pocket on underside of rainfly illus 10 Completed tent with rainfly 1 Rainfly pole pocket Rainfly pole pockets Underside of rainfly attaches to frame poles CA Y RSA illus 9 Things You Should Know Under certain conditions cold weather high humidity etc condensation will form on the inside surfaces of your tent Condensation is caused by water vapor from your breath perspiration or any wet clothing inside your tent It is NOT LEAKAGE through the tent fabric It can be minimized by removing wet clothing from your tent and by
3. providing good ventilation through the tent Never store tent even for a short period of time without drying it thoroughly and brushing off caked dirt Do not pack stakes or poles inside your tent Use a separate storage bag STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE Seam sealer has not been provided with your tent For additional protection we recommend seam sealing your tent prior to camping Seam sealer may be purchased through your local retailer or at your local sporting goods store PRINTED IN CHINA REV 7 04 Do not leave your tent set up for weeks at a time be aware that exposure to the ultraviolet rays of the sun can seriously damage material and or cause it to become discolored WARNING KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC This tent meets the flammability requirements of CPAI 84 The fabric will burn if left in continuous contact with any flame source The application of any foreign substance to the tent fabric may render the flame resistant properties ineffective THE COLEMAN CO INC 3600 N Hydraulic e Wichita Kansas 67219 1 800 835 3278 www coleman com MADE IN CHINA
Download Pdf Manuals
Related Search