Metra AX-ADXSVI-FT1 car kit
Contents
1. 1 800 221 0932 ke metraonline com REV 12 17 13 COPYRIGHT 2004 2013 METRA ELECTRONICS CORPORATION2. INSTAX ADXSVI FT1 AX ADXSVI FTI1 Fiat 500 accessory and NAV output CAN interface 2012 up e Provides accessory 12 volt 10 amp Retains R A P retained accessory power Used in both amplified and non amplified systems Provides NAV outputs parking brake reverse and V S S Prewired ASWC 1 harness included ASWC 1 sold separately High level speaker input Retains OE BT USB and 3 5mm audio USB updateble Note This harness must be used in conjunction with the AX ADXSVI APPLICATIONS FIAT 000 2012 up WIRING UP THE AX ADXSVI FT1 Connect the Yellow wire to the radio s 12 volt battery or memory wire Connect the Black wire to the radio s ground wire Connect the Red wire to the ignition wire of the aftermarket radio Connect the Orange wire to the illumination wire of the aftermarket radio If the aftermarket radio has no illumination wire tape off the Orange wire Connect the Blue White wire to the radio s amp turn on wire Connect the White wire to the left front positive speaker output of the aftermarket radio Connect the White Black wire to the left front negative speaker output of the aftermarket radio 1 800 221 0932 m metraonline com REV 12 17 13 COPYRIGHT 2004 2013 METRA ELECTRONICS CORPORATION INSTAX ADXSVI FT1 Connect the Gray wire to the right front positive speaker output of the aftermarket radio Connect the Gray Black wire to the right front negative speaker output of the aftermarket radio Connec
3. t the Green wire to the radio s left rear positive speaker output Connect the Green Black wire to the radio s left rear negative speaker output Connect the Purple wire to the radio s right rear positive speaker output Connect the Purple Black wire to the radio s right rear negative speaker output The following wires are for the aftermarket radios that have navigation built in Connect the Light Green wire to the parking brake wire of the aftermarket navigation radio if applicable Connect the Blue Pink wire to the VSS or speed sense wire of the aftermarket navigation radio if applicable Connect the Green Purple wire to the reverse wire of the aftermarket navigation radio if applicable Plug the AUX 3 5mm or BT USB RCAs to the aftermarket radio s audio AUX input Cycle the key by turning the ignition on for 30 seconds then off and on again to test the radio ASWC 1 if installing After the XSVI is initialized plug in the ASWC into the 12 pin harness of the AX ADXSVI FT1 and refer to the ASWC instructions Se ee ee ee Caution Metra recommends disconnecting the gt mo electronico School n our ind negative battery terminal before beginning any Bt 8762 for more iformatin anak tps installation All accessories switches and especially air bag indicator lights must be plugged in before reconnecting the battery or cycling the ignition Se Note Refer to the instructions included with the se aftermarket radio
Download Pdf Manuals
Related Search