Havis C-VS-1300-TBZ car kit
Contents
1. back Mark Measurement with tape T15 Torx from shift lever boot Position shift lever in drive or Note In order to remove console Remove front trim to aid in running further back Remove entire you must reach up inside the shifter additional wiring console assembly boot and disconnect the traction control plug 2 C VS 1300 TBZ_INST_6 09 docx6 09 Extend cut line on console sides Carefully reinstall front console Reattach shift lever T handle Carefully cut off back console section section Jig saw Air saw Dremel Reattach Traction Control Plug or Air drill Remove inboard rear seat nuts Attach bail bracket onto rear hump Place duct block off plate in duct 15mm Place new rear hump brackets with 4 x 3 4 bolts opening and screw down with 10 x brackets on seat studs under seat Note You may need to bend hump 2 sheet metal screw brackets brackets slightly forward Attach L mount brackets to new Place new console between seats Position console housing as desired console lower side tracks with 1 4 x and position L mount brackets and tighten all mount hardware Y2 bolts and washers onto OEM bracket Attach with Check shift lever in rear position T eave loose to aid in positioning 1 4 x 3 4 bolts 3 C VS 1300 TBZ_INST_6 09 docx6 09 Finish wiring and complete installation A C VS 1300 TBZ_INST_6 09 docx6 092. Havis Inc 75 Jacksonville Road PO Box 2099 Warminster PA 18974 T 800 524 9900 F 215 957 0729 www havis com HAVIS Productivity in motion INSTALL INSTRUCTIONS C VS 1300 TBZ VEHICLE SPECIFIC CONSOLE 2002 2009 CHEVROLET TRAILBLAZER TOOLS REQUIRED Q Phillips screwdriver Q 15mm socket a T 15 Torx driver Q Jig Saw or plastic cutting tool a T 20 Torx driver a Eye goggles Q 7 16 wrench Q Ratchet wrench Q 7 16 socket HARDWARE QTY DESCRIPTION PART 1 Trailblazer vehicle specific console C VS 1300 TBZ H 1 Bail bracket C Bl 1 Rear hump bracket set C B27 1 Duct block off plate CM001516 2 Side L brackets CM93594 1 Console hardware kit C HK 1 Torx screw kit C HK 1 1 10x1 2 PPHSMS Block off plate screw GSM33194 Always gt Read all instructions before installing any Havis Inc products Disconnect the vehicle battery Removing seat bolts on some vehicles may give the vehicles computer a false reading causing a warning light on the instrument cluster This requires the vehicles computer to be reset with a vehicle diagnostics tool Check for obstructions Wire brake lines fuel tank etc before drilling any holes Use only hardware provided with install kit Remove six phillips screws that hold inner storage pocket Remove storage pocket and arm rest assembly Remove main console screws Unplug wires for rear controls AAAS eae Remove shift lever T knob Measure approximately 3 2
Download Pdf Manuals
Related Search