Argoclima Rock
Contents
1. CE CERAMIC FAN HEATER AND AIR PURIFIER rock OPERATING INSTRUCTIONS Read the instructions carefully before installing and operating the appliance or performing maintenance operations Observe all the safety instructions failure to observe the instructions may cause accidents and or damages Store these instructions for future reference V 05 13 T GENERAL SAFETY INFORMATION e Use this fan heater only as outlined in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to people Ensure that the mains power complies with the voltage specified on the fan heater s data plate 220 240V 50HZz This product is not a toy Children should be adequately supervised to ensure that they do not play with the appliance This appliance is not suitable for use by people including children with reduced physical sensory or mental abilities or without the necessary experience and knowledge unless they have been adequately supervised and instructed concerning use of the appliance by a person responsible for their safety Do not restrict the air inlet and outlet grilles e The appliance heats up slightly when in use In order to avoid burns do not let bare skin touch hot surfaces Ensure that all objects are at least 1 meter from the front and sides of the appliance Disconnect the mains power when the appliance is not used or for cleaning operations Avoid using the fan heater in dus2. connecting the fan heater e Do not place any objects on the cord and do not bend it It is not advisable to use extension cords as these may overheat and cause the risk of fire Do not use a single extension cord to operate multiple appliances e Do not immerse the cord plug or any other element of the appliance in water or other liquids Do not touch the plug with wet hands e Do not place the fan heater above or near another heat source WARNING AVOID COVERING THE FAN HEATER TO PREVENT IT FROM OVERHEATING The symbol below signals the above warning D e The fan heater may cause the risk of fire if while in operation is covered by or comes into contact with inflammable material including curtains drapery blankets etc KEEP THE FAN HEATER AWAY FROM THESE MATERIALS e Do not connect the appliance to the mains power before it has been properly assembled and positioned e Do not run the cord under carpets Do not cover the cord with blankets carpets or similar materials Place the cord far away from busy areas or where it cannot be accidentally pulled out e Do not operate the fan heater in close proximity to bathtubs showers washbasins or pools e Do not position the fan heater below a socket outlet e Do not operate the appliance outdoors WARNING do not use the fan heater with a controller or any other external device that activates the appliance automatically as there may be a risk of fire if the fan heater is covered or
3. incorrectly positioned Upon initial start up the fan heater may emit a slight harmless smell This smell is a normal effect of the initial heating up of the internal heating elements and should not recur later on WARNING DO NOT DEPEND ON THE ON OFF BUTTON SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN SERVICING OR MOVING THE FAN HEATER ALWAYS UNPLUG THE POWER CORD e A fan heater has hot and arcing or sparkling parts inside It must not be used in potentially dangerous locations such as flammable explosive chemical laden or wet atmosphere e Do not place the fan heater on soft surfaces like a bed where openings may become blocked Always place the fan heater on a stable flat level surface when operating to avoid the chance of the fan heater overturning Locate the power cord so the fan heater or other objects are not resting on it Always unplug the fan heater when not in use In order to avoid accidents turn unit off if unattended In the event of any problems abnormal noise or a strange smell switch off the appliance immediately do not attempt to repair it and take it to your local after sales service V 05 13 8 DESCRIPTION OF PARTS 1 Control panel 2 Liquid crystal display 3 Air delivery grille 4 Handle 5 Base 6 Intake grille 7 On off button 8 UV lamp 9 lon emission FRONT VIEW REAR VIEW HOW TO USE THE FAN HEATER Position the unit on a flat stable surface Connect the power cord to a s
4. lace battery when its electricity charge is used up please do not eliminate this battery together with normal household waste It must be taken to special local community waste collection centres or to a dealer providing this service Disposing of a battery separately avoids possible negative effects on the environment and human health deriving from an inappropriate disposal and enables its components to be recovered and recycled to obtain significant savings in energy and resources In order to underline the duty to dispose of this equipment separately the battery is marked with a crossed out dustbin MAINTENANCE AND STORAGE ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE IMPORTANT DO NOT SUBMERGE THE CERAMIC FAN HEATER IN WATER Cleaning the outside surface of the appliance Turn the switch off and unplug before carrying out any maintenance work or moving the appliance Use a soft cloth to remove any dust from the fan heater If the fan heater is excessively dirty use a soft cloth moistened with water and a mild detergent at a temperature lower than 50 C Let the fan heater dry completely before use Do not use corrosive detergents or solvents such as petrol Do not wash the appliance with water Do not use oils chemical substances or other items to clean that may damage the surface Use a vacuum cleaner to remove dust from the air inlet outlet grilles Cleaning the filter Clean the filter frequently based on the en
5. t temperature NOTICE This appliance is equipped with 1 An UV lamp with germicidal effect 2 A ionizer it emits negative ions and purifies the air in the room Both are always active while the appliance is in operation The appliance is fitted with an anti tip up device that prevents it from operating when it detects that the product is inclined Do not position the appliance on its side or upside down WARNING ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE WHEN YOU TURN THE APPLIANCE ON AGAIN AFTER SWITCHING IT OFF BY MEANS OF THE BUTTON ON OFF AND REMOVING THE PLUG FROM THE SOCKET YOU HAVE TO RESET THE DESIRED MODE ECO COMFORT TEMPERATURE AND OSCILLATION FUNCTION SWING V 05 13 10 REMOTE CONTROL Mode selection ON OFF button button ECO or COMFORT Buttons SWING button TIMER TEMPERATURE button The remote control uses Lithium Manganese button cells model no CR2032 3 V compliant with Battery Directive no 2006 66 CE supplied with the remote control HOW TO INSERT REMOVE THE REMOTE CONTROL BATTERIES refer to the diagram below Open the battery cover at the rear of the remote control press and pull the cover Place the battery into the cover observing the correct polarity Insert the cover onto the remote control Z M Battery Installation Information for correct disposal of the battery in accordance with the European Directive 2006 66 EC Please rep
6. ty environments or in the presence of inflammable vapours e g in workshops or garages or paint vapours e Do not place anything on the appliance use the appliance to dry clothing Use the appliance in a well ventilated area Avoid placing fingers or foreign objects in the air inlet outlet grilles as this may lead to electric shock or fire and may damage the appliance To avoid the risk of fire do not block the grilles or tamper with them in any way while the fan heater operates e Do not use the appliance if the cord or plug are damaged If the power supply cord is damaged it must be replaced by the manufacturer dealer or a similarly qualified person so as to avoid any safety risks e Do not operate the appliance if it has fallen from a height or has suffered damage in any way Contact qualified technical personnel to examine the appliance or perform any electrical or mechanical repairs e The most common cause of overheating is the build up of dust in the appliance Remove dust deposits by unplugging the appliance and cleaning the air outlets and grilles with the aid of a vacuum cleaner e Do not use abrasive detergents for cleaning this appliance Clean the appliance with the aid of a damp not wet cloth rinsed in hot soapy water Always remove the plug from the mains socket before cleaning e To disconnect the fan heater push the switch to OFF and remove the plug from the socket Pull on the plug only Avoid pulling on the cord when dis
7. uitable electric socket 220 240V 50HZz When you move the appliance use the handle On off button on the rear above the intake grille Bring the on off button to the I position When the appliance emits a beep this means that the fan heater is ready for use Bring the button to the 0 position to switch off the fan heater LED DISPLAY ECO mode LED 1000 W reduced power to save Room temperature energy timer on setting COMFORT mode LED maximum heating power 2000W Temperature display room temperature display room temperature setting Remote control receiver lonization C display hour UV lamp display Timer display 7 Timer display setting Swinging display V 05 13 9 CONTROL PANEL SWING button Buttons t and When the unit is operating touch the Allows you to adjust the SWING button to make the appliance ON OFF button temperature and timer settings of oscillate automatically shifting the air Touching the ON OFF button the the appliance flow from left to right The LED ee is appliance will begin to operate switched on simultaneously Touching the button ON OFF once again Touch the SWING button once again to the appliance will switch off To switch interrupt the oscillation and switch off the off the fan heater completely place the LED 2 on off button in the 0 position ae ON OFF SWING ECO COMFORT selection button B ECO mode 1000 W reduced power to sa
8. ve energy COMFORT mode maximum heating power 2000W TIMER TEMPERATURE button When the appliance is operating the operating time can be set by touching this ECO is the default mode when the set button the timer display shows a flashing 0 and the and buttons can be temperature is higher than room operated to set the desired time between 1 and 23 hours with each touch temperature corresponding with 1 hour The display shows the set time wait 5 for the setting to be confirmed The unit will switch off automatically at the end of the programmed time After the timer has been set touching the button once again will allow you to set the temperature the display will show ambient temperature and by operating the and buttons the desired temperature can be set between 15 and 35 C Once the desired temperature has been set wait 5 for the setting to be confirmed After 5 the display will show the ambient temperature once again NOTICE The default temperature is 17 C NOTICE When you switch on the appliance the temperature set by default is 17 C In order to activate heating function you need to set a temperature of about 2 above room temperature In this case ECO mode is in automatically in operation only when heating is active you can select COMFORT mode if desired When the set temperature is reached the icon ECO or COMFORT turns off and turns back again only when room temperature falls below the se
9. vironmental conditions under which the appliance is used a dirty filter may reduce the air flow rate and prevent the fan heater from working properly Remove the filter by pressing and pulling as shown in the diagram below Clean the filter using a vacuum cleaner and wash in water using a neutral detergent at a temperature below 30 C Let the filter dry after washing and refit it on the fan heater V 05 13 11 STORAGE Air filter Appliance casing Filter cover If the appliance is not used for prolonged periods it must be stored together with this manual in its original packaging in a cool and dry place V 05 13 Information for correct disposal of the product in accordance with the European Directive 2002 96 EC At the end of its working life this equipment must not be disposed of as an household waste It must be taken to special local community waste collection centres or to a dealer providing this service Disposing of electrical and electronic equipment separately avoids possible negative effects on the environment and human health deriving from an inappropriate disposal and enables its components to be recovered and recycled to obtain significant savings in energy and resources In order to underline the duty to dispose of this equipment separately the product is marked with a crossed out dustbin improve your life www argoclima com 12
Download Pdf Manuals
Related Search