Home
Doro HearPlus 313ci
Contents
1. 2 to set the minutes day and month ENGLISH is displayed Use A V to select the desired language then confirm with N English 2 CONTRAST Use A V to set the display contrast setting 1 4 and confirm with 24M KEYT ON Use A V to set key tone ON OFF and confirm with 24M 100 FLASH Use A V to set the flash key time 100 300 600 ms and confirm with 2A The standard setting is 100 for most countries 300 for France Portugal 600 for New Zealand LED OFF Use A V to enable disable the LED indicator for new calls and confirm with 2A TONE Use A V to select either tone or pulse dialling mode and confirm with 7A Note If unsure of which mode to use select TONE as this works in most locations English Wall mounting The telephone can be wall mounted by using the included wall mount bracket and two screws not included Warning Make sure that no cables water pipes or gas pipes are located inside the wall before drilling into it 1 Drill two holes in the wall vertically 83 mm apart 2 Insert the screws allowing them to project 5 mm out from the wall 3 Unplug and remove the handset 4 Fit the guide tabs A on the bracket into the slots B on the back of the telephone then slide the bracket upwards until it snaps into place English 5 Position the telephone so that the screws on the wall fit into the slots in the bracket then slide the
2. and hold M until a blinking cursor is shown 2 Enter a telephone number up to 22 digits Use L V to move the cursor and C to erase if needed Use fill to insert a pause in the number 3 Press XX to confirm A blinking cursor will be shown on the second line on the display 4 Enter a name up to 9 characters for the number to be stored see Keypad characters 5 Press 2J to confirm OK is now displayed 6 Repeat steps 1 6 to store another number or press and hold C to exit Deleting numbers from the phone book 1 Press N to open the phone book 2 Use A W to browse through the phone book or enter the first character to quickly find an entry 3 Press and hold C to delete the entry 10 English Editing numbers in the phone book 1 2 3 4 5 6 7 Press M to open the phone book Use A W to browse through the phone book or enter the first character to quickly find an entry Press and hold MQ until the blinking cursor appears Use A W to move the cursor and use C and the keypad to erase and enter new data Press MW to confirm The cursor will move to the second line Repeat step 4 to edit the name description Press JM to confirm OK is displayed Storing speed dial numbers 1 Press and hold one of the speed dialling keys A B C until a blinking cursor is shown on the first line on the display Enter a telephone number up to 22 digits using the keypad Use
3. A V to move the cursor and C to erase if needed Use fl to insert a pause in the number Press XX to confirm A blinking cursor will be shown on the second line on the display Enter a name up to 9 characters for the number to be stored see Keypad characters Press 7J to confirm OK is displayed Repeat steps 1 5 to store numbers for the other speed dialling keys 11 English Deleting speed dial numbers Speed dial numbers can not be deleted they can only be replaced by storing a new number Caller ID and call memory Caller ID allows you to see who is calling before you answer and to see who has called in your absence Note The Caller ID function must be subscribed Please contact your network operator for more information The call memory will store the last 15 incoming and 15 outgoing calls On the display incoming answered and unanswered calls are indicated with M and outgoing calls with A If the Call Indicator function is active a blinking light indicates that an unanswered call has been received since the call memory was last checked Browsing the call memory 1 Press JM then A V to scroll through the call memory The number and time of each call will be displayed For calls older than 24 hours the date of the call is displayed instead of the time 2 Press C to exit the call memory Deleting numbers from the call memory 1 Press XM then A V to scroll through the call m
4. English doro O HearPlus 313c dilata n liu gt ne DOO E WOG DI English Telephone line socket Handset hook Keypad Handset cord socket Handset volume Recall Volume boost Call memory OK Delete 10 Mains adapter socket 11 Ring tone OMANAUARWNe fe me Cc dC D F 12 Ring melody 13 Ring volume 14 Speed dial keys 15 Phone book 16 Handset tone 17 Speaker volume 18 Speakerphone 19 UP DOWN 20 New call indicator 21 Ringer indicator English Description Doro HearPlus 313ci This product can be used as a desktop or wall mounted telephone Handset tone control volume boost enhanced ring volume and visual call indication make the telephone well suited for people with hearing difficulties The extra large keypad and easy to read display with large characters make the telephone easy to use even with impaired eyesight The built in phonebook can store up to 30 names and numbers Three one touch memory keys can be programmed for frequently used numbers or emergency numbers A call memory logs the 15 most recently incoming and outgoing calls A speakerphone function allows you to talk hands free with the simple press o
5. aration of Conformity is available at www doro com dofc UK Technical support is available by email on tech doro uk com Premium rate telephone number 0905 895 0854 calls cost 50 pence per minute price correct at the time of publication You can also contact us in writing regarding any Spares or Technical query Customer Services Doro UK Ltd 1 High Street Chalfont St Peter Buckinghamshire L9 9QE Further contact details are available on our website www doro uk com 16 English Version 1 0 CE
6. emory 2 Press and hold C to delete the selected entry 12 English Copying call memory entries to the phone book 1 Press Wh then A V to scroll through the call memory 2 Press and hold Ed until OK is displayed The selected number has now been saved to the phone book Call timer The display shows the current time when in standby mode During a call the display will show a call timer instead indicating the duration of the call The call duration is displayed for 5 seconds after the call is terminated Recall key R Ge C Y Press the a key followed by the extension number to transfer a call when connected to a PBX system Additional network services may be accessible by using the R EJ and M keys Please contact your network operator for more information about the available network services 13 English Hearing aid This telephone is hearing aid compatible Select the T mode on your hearing aid to enable this feature Volume Boost The handset volume can be raised another 10 dB by pressing the Volume Boost key while talking The LED indicator on the key will light up Press the key again or terminate the call to turn off Volume Boost Warning The handset volume can be very loud with this setting Volume boost should only be used by persons with impaired hearing ae Handset tone The speech tone bass treble can be adjusted for better clari
7. f a button English Installation Connection 1 Connect the curly cord to the handset and to the socket marked amp on the telephone 2 Connect the telephone line cord to a network wall socket and to the Z socket on the back of the telephone 3 Connect the mains adapter to the mains power wall socket and to the DC 9V socket on the telephone 4 Lift the handset and listen for the dial tone Batteries Four AA alkaline batteries are needed for the call memory and speakerphone in the event of a power cut When BATT LOW is displayed replace all 4 batteries Use only AA alkaline batteries of good quality not included Note Before installing or changing the batteries make sure that the telephone is not connected to the telephone network 1 Remove the battery cover and insert the batteries ensuring correct battery polarity is observed 2 Replace the battery cover and reconnect the telephone line cord English Basic setup Before using the telephone the first time the following basic settings should be made After confirming a setting the next setting is automatically displayed To skip to the next setting press MW The phone will return to standby mode after 30 seconds of inactivity or when pressing C On first setup the display clock will show 00 00 1 Press and hold for about 5 seconds until the hour flashes 2 Use A V to change the value and confirm with 24M 3 Repeat steps 1
8. ls M Incoming call A Outgoing call 3 Lift the handset or press to dial the displayed number Speed dial one touch dialling 1 Press one of the speed dialling keys A B C The Stored telephone number is displayed 2 Lift the handset or press to dial Dialling numbers in the phone book 1 Press N to open the phone book 2 Use A V to browse through the phone book or enter the first character in the name to quickly find an entry see Keypad characters 3 Lift the handset or press to dial Answering Lift the handset to answer an incoming call or press amp to answer using the speakerphone English Ring signal The ring melody and tone can be adjusted using the sliders on the bottom of the telephone d d Ring melody sx 9 Ring tone The ring volume is adjusted with the switch on the right side of the telephone Volume control The speaker volume is adjusted with a slider on the right side of the telephone The handset volume control is located under the handset Keypad characters RA Space amp X1 ieri ABCA AE waak2r RR DEF 3A WIRE GHIi40 Sea dete tee JKL5L 6 Pee E MNONA 6 EIA PQRS7n gt S Re ee ee errr re TU v u 8 EE EE E T WXYZ9DWO XE lt gt 0 0 Pe eee _ K English Additional functions Phone book The phone book can store up to 30 entries When the memory is full 100 is displayed Storing numbers in the phone book 1 Press
9. should please contact the place of purchase for service Don t forget the receipt or a copy of the invoice 15 English Warranty and technical data This product is guaranteed for a period of 24 months from the date of purchase In the unlikely event of a fault occurring during this period please contact the place of purchase Proof of purchase is required for any service or support needed during the guarantee period This guarantee will not apply to a fault caused by an accident or a similar incident or damage liquid ingress negligence abnormal usage non maintenance or any other circumstances on the user s part Furthermore this guarantee will not apply to any fault caused by a thunderstorm or any other voltage fluctuations As a matter of precaution we recommend disconnecting the device during a thunderstorm Batteries are consumables and are not included in any guarantee Use only AA Alkaline batteries of good quality NOTE This guarantee does not affect your legal statutory rights under your applicable national laws relating to the sale of consumer products Specifications Size 175 mm x 175 mm x 60 mm Weight 750 g including batteries Battery 4 x 1 5 V AA Alkaline batteries Declaration of Conformity Doro hereby declares that Doro HearPlus 313ci conforms to the essential requirements and other relevant regulations contained in the Directives 1999 5 EC R amp TTE and 2002 95 EC RoHS A copy of the Decl
10. telephone downwards until it is hanging on the screws 6 Remove the handset hook C by pushing it upwards and insert it in the reversed position so that the small tab D protrudes The hook will now keep the handset in the cradle when the phone is wall mounted des Lf o o o o o o 08 o o o o E 0 0 6 no oo n 7 Reconnect the handset and place it in the cradle Note If the phone is to be used as a desktop phone again remember to reverse the position of the handset hook English Operation Making a call Normal dialling 1 Lift the handset 2 Dial the number Hang up the handset to terminate the call Speakerphone Note The speakerphone only works when batteries are installed or mains adapter is connected 1 Press to activate the speakerphone The LED next to the key will light up 2 Dial the number Press amp again to terminate the call Lift the handset to switch from speaker to handset during a call Pre dialling 1 Enter the number Press C to delete the last entered digit 2 Lift the handset or press to dial English Quick redial 1 Lift the handset or press Ge 2 Press ZZ to redial the last dialled number Dialling numbers in the call memory 1 Press XXX to display the most recent call 2 Use A W to scroll through the last 15 incoming and outgoing cal
11. ty using the handset tone control on the right side of the phone PLEASE NOTE Only works when Boost is active 14 English Care and maintenance Your unit is a technically advanced product and should be treated with the greatest care Negligence may void the warranty Protect the unit from moisture Rain snowfall moisture and all types of liquid can contain substances that corrode the electronic circuits If the unit gets wet you should remove the battery and allow the unit to dry completely before you replace it Do not use or keep the unit in dusty dirty environments The unit s moving parts and electronic components can be damaged Do not keep the unit in warm places High temperatures can reduce the lifespan for electronic equipment damage batteries and distort or melt certain plastics Do not keep the unit in cold places When the unit warms up to normal temperature condensation can form on the inside which can damage the electronic circuits Do not try to open the unit in any other way than that which is indicated here Do not drop the unit Do not knock or shake it either If it is treated roughly the circuits and precision mechanics can be broken Do not use strong chemicals to clean the unit The mains socket outlet shall be installed near the equipment and shall be easily accessible The advice above applies to the unit battery mains adapter and other accessories If the telephone is not working as it
Download Pdf Manuals
Related Search
Related Contents
User Manual PROCESSEUR DE SIGNAUX MIDI MANUEL D`UTILISATION T128 French IB 121012 Kurtarma, Yedekleme ve Sorun Giderme Kılavuzu ベ ロ ー ズ 形 伸 縮 管 継 手 建築設備・空調設備 工場設備 など JB ioLogik R2140 Series User`s Manual v3 Samsung B308 User Manual Océ 7050/7051 Samsung HT-Q20 Manuel de l'utilisateur 1 BIJSLUITER VOOR HET PUBLIEK Benaming Copyright © All rights reserved.
Failed to retrieve file