Gamber-Johnson Surface Base
Contents
1. INSTALLATION INSTRUCTIONS Product Revision Form Horizontal Surface Base B INST 14 DS 56 1 First mount the head or rack on the base following the instructions furnished with the head or rack 2 With the head or rack in the center of tilt range locate the assembly on the mounting surface in the desired position Mark the locations of the four mounting holes 3 Drill a 18 32 hole at each mounting hole location using care not to damage any equipment below the mounting surface Use machine bolts and nuts of the largest size that will fit the holes in the base Most bases have hoes for 3 8 bolts but holes for 1 2 bolts are furnished in the taller bases 4 Place bolts washers and nuts in all holes and tighten We strongly recommend fender washers if the mounting surface is less than 1 8 thick Do not use lag screws or sheet metal screws as these can pull out of the floor Product Mounting Disclaimer Gamber Johnson is not liable under any theory of contract or tort law for any loss damage personal injury special incidental or consequential damages for personal injury or other damage of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application In order to safely install and use Gamber Johnson products full consideration of vehicle occupants vehicle systems i e the location of fuel lines brakes lines electrical drive train or oth2. er systems air bags and other safety equipment is required Gamber Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications and recommendations Gamber Johnson product instruction sheets or workmanship standards as endorsed through the Gamber Johnson Certified Installer Program If you need assistance or have question call Gamber Johnson at 1 800 456 6868
Download Pdf Manuals
Related Search