Gamber-Johnson Universal Vehicle Base
Contents
1. INSTALLATION INSTRUCTIONS Product Date Form DS 146 06 14 2006 INST 300 Vehicle base for International Freightliner amp Sterling Trucks The instructions that follow describe the method of installation recommended by the manufacturer This base is designed for International Freightliner and Sterling trucks but may also be used in other large trucks with bench style seats The DS 146 is designed to be bolted to the floor and to the top front rectangular rail of the bench style seats found in some large trucks In order to securely fasten this base drilling into the vehicle will be required WARNING 1 FOLLOW ALL SAFETY PROCEDURES SUCH AS WEARING EYE PROTECTION WHEN DRILLING 2 BEFORE DOING ANY DRILLING MAKE SURE TO CHECK UNDER AROUND AND INSIDE THE VEHICLE TO ENSURE THAT THE THE HOLE PLACEMENT WILL NOT DAMAGE ANY WIRING TUBING OR DEVICES 1 Loosen the 3 8 16 fasteners carriage bolts and nuts see FIG 1 Place the assembly in the vehicle and find the desired position Use this position to adjust the height of the base A x 3 8 16 Fastener Mount so that it will rest flat on the two points of contact with the seat frame and the floor see FIG 2 2 Depending on the model of your vehicle there may be holes in the seat frame already It is recommended to use the pre existing holes in the seat frame If the seat frame has no existing holes place the base in the desired position FIG 1 mark the locations2. on the seat frame DS 146 Assembly 3 8 16 Fastener where the mounting holes will need to be drilled remove assembly and drill holes using a 3 8 drill bit seat Frame 3 Loosely assemble the appropriate length fasteners NOT INCLUDED and the base to the seat frame With the Foot see FIG 1 resting on the floor mark the locations for the holes remove the assembly and drill completely through the floor of the vehicle Again make sure that there are no interfering components of the vehicle in the position chosen for mounting 4 With all of the holes drilled place the base back into position loosely bolt the Mount to the seat frame Loosen the four 3 8 16 fasteners holding the assembly together Loosely A r fasten the Foot of the assembly to the floor Adjust the FIG 2 assembly so that it rests flat on the seat frame and the floor DS 146 Installed Floor 5 Finally tighten all the hardware This concludes the installation of the DS 146 Product Mounting Disclaimer Gamber Johnson is not liable under any theory of contract or tort aw for any loss damage personal inury special incidental or consequential damages for personal injury or other damage of any nature arising directly or indirectly asa result of the improper installation or use of its products in vehicle or any other application In order to safely install and use Gamber Johnson products full consideration of vehicle occupants vehicie systems 1 e the location of f
3. uel lines brakes lines electrical drive train or other systems air bags and other safety equipment is required Gamber Johnson specitically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications and recommendations Gamber Johnson product instruction sheets or workmanship standards as endorsed through the Gamber Johnson Certified Installer Program If you need assistance or have questions call Gamber Johnson at 1 800 456 6868
Download Pdf Manuals
Related Search