Uncle Milton Moon In My Room
Contents
1. With Light up Lunar Phases Installing batteries into Moon In My Room T Tool required Small Phillips head screwdriver e Non rechargeable batteries are not to be recharged e Rechargeable batteries are only to be charged under adult supervision sas e Rechargeable batteries are to be removed from the toy before being charged 1 Use a Phillips head screwdriver to remove the Different types of batteries or new and used batteries are not to be mixed battery cover see Fig 1 e Batteries are to be inserted with the correct polarity e Exhausted batteries are to be removed from the toy e The supply terminals are not to be short circuited 2 Insert 4 AA batteries Make sure the and ends are inserted correctly as indicated in the battery compartment Battery 3 Replace cover Figure 1 cover 4 IMPORTANT Switch Moon in My Room to the ON position before handing on the wall see Fig 2 PLEASE NOTE The unit will not activate without the remote control Installing batteries into the remote control Tool required Small Phillips head screwdriver 1 Use a Phillips head screwdriver to remove the battery door see Fig 3 2 Insert 2 AAA batteries Make sure the and ends are inserted correctly as indicated in Figure 2 the battery compartment 3 Replace cover Figure 3 Hanging Moon In My Room ON OFF Hanging holes NOTE The Moon In My Room is only inten2. Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications KEEP THESE INSTRUCTIONS FOR However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or FUTURE REFERENCE DO NOT DISCARD television reception which can be determined by turning the equipment off Vie and on the user is encouraged to try to correct the interference by one or Questions Visit us at unclemilton com more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to MANUFACTURED BY UNCLE MILTON INDUSTRIES INC which the receiver is connected P O Box 6281 Consult the dealer or an experienced radio TV technician for help o THOUSAND OAKS CA 91359 USA 2011 UMI All rights reserved and TM designate trademarks of Uncle Milton Industries Inc MADE IN CHINA 2056 0250 0411
3. ded to hang on a vertical wall 1 Hang the Moon In My Room by one of the three hanging holes see Fig 4 2 Select any one of the 3 hang holes to angle the moon to your desired position This directly affects the angle of the crescents Using Moon In My Room IMPORTANT Before operating be sure on off switch located on the back of Moon In My Room is turned to the ON position NOTE n order for the moon to function properly the room lights should be off Figure 4 On Off Manual phase To turn the moon off press the ON OFF button on button your remote Press ON OFF button again to On Off reactivate a full moon button Auto Off Moon automatically shuts off after 30 minutes if there eesti is no Manual interaction phase button Manual Phase To manually cycle through the moon phases press the manual phase button see figure 5 If you leave the moon on in a phase it will automatically turn off after 30 minutes Figure 5 Auto Phase Your Moon In My Room will cycle through the moon S PoP Caution changes or modifications not expressly approved by the party phases automatically when you push the automatic responsible for compliance could void the user s authority to operate the phase button The moon will cycle from phase to phase in a five second intervals In this mode the moon will NOTE This equipment has been tested and found to comply with the limits for automatical ly turn off after 30 minutes a
Download Pdf Manuals
Related Search