Ergotech Group 100-D16-B03-ICE flat panel desk mount
Contents
1. quick release clip by lifting the bottom slightly as VV I ul L Ul IG rA Nl Li Mol 1 if v7 y Ji UW V WW CU J SMS i To tile the monitors horizontally Turn the handle on the top of the micro height adjustable pivots until the three monitors are properly aligned To remove the monitors from the extrusions Take the weight from the monitor with one hand on the bottom and tip it back slightly while using the other hand to lift the top of the silver release button Lift up and back and this will release the monitor from the stand OCT 08 www ergotechgroup com2. ERGOTECH GROUP INC 8 Westchester Plaza ERGOTEC H Elmsford NY 10523 914 347 3800 instalation Instructions 1 Remove the base from the box and place it on a flat surface 2 Insert the pole into the cone by threading the pole onto the PEM stud on the base and then tightening the set screw with the 3mm Allen key provided Be certain the pole is fully seated and tightened into the cone and the set screw is securely tightened 3 Place the arm assembly over the pole with the grooves in the extrusions facing up Allen key 4 Tighten the T handle on the back side of the pole clamp to hold the arm assembly securely on the pole 5 Attach quick release pivots to back of each monitor with screws provided Be sure that silver release button is toward the top of the monitor 6 Starting with the center monitor standard pivot place it onto the middle extrusion by tipping it back approximately 45 degrees and then down until the silver button engages the groove and clicks down into place Repeat this process with the two lateral adjustable monitors micro height adjustable pivots i piya standard pivot To adjust monitors To slide along extrusion Lift the monitor from the bottom until it slides freely along the extrusion EARS Ra groove and then slowly release your support until it drops back into its secured position The monitor will D not slide easily until weight is removed from the
Download Pdf Manuals
Related Search