Chief 14U
Contents
1. larger tubing things with holes up the sides to the underside of the shelf as shown with 4 more of the same screws and drop the uprights into the recievers as shown The knobs pull out then turn to remain open so that you can find the shelf height that you are comfortable with then turn them all back at once when you are near slightly above the position that you want When they all find their holes they will click into place securely o 0 Joo0000002. Studio Furniture Instruction Sheet Config u raxx Side Wing Racks Steel Step 1 Place the two side panels on a clean flat surface with the holes facing up If you are going to use the Raxxess SFRD door you ll want to place the rails on the side with the flat moulding on the front edge If you are not using a door you ll want to place the rails on the side that has the silver t mould but the choice is yours Place the Rack rails on them lining up the small pilot holes in the panels with the 1 4 holes in the rack rails Drive 4 black wood screws into the matching holes securing the rails in place with the small holes facing the front as shown Next place the cams little cyinder thingies into the holes as shown with the arrows on the cams facing the top of the panel Place one of the side panels in the position shown next to the rack base Run 4 1 4 20 x 1 1 4 screws with washers into the sides of the panel and into the appropriate holes in the base Now do the same thing with the other side panel leaving all screws loose until they are all in then tighten them securely Raxxess Metalsmiths 261 Buffalo Avenue Paterson N J 07503 Made with pride in the U S A Page 1 of 3 Studio Furniture Instruction Sheet Config u raxx Side Wing Racks Step 3 Now let s prep the table top First you ll have to decide if you prefer the forward or rear position for your top The forward positi
3. on gives you better access to the gear at the front of the rack The rear position will provide more legroom and therefore will limit access to the gear Once you decide place the 6 studs in the forwardmost holes or the rearwardmost is that even a word holes as shown Step 4 Next check that the arrows on the cams are facing the open holes on the top end of the rack assembly then place the rack assembly over the top in the position shown and drop it down on the studs Be sure to carefully line up the studs with the holes in the top of the rack then tighten the cams turning clockwise with a large straight screwdriver Raxxess Metalsmiths 261 Buffalo Avenue Paterson N J 07503 Made with pride in the U S A Page 2 of 3 1 1 Raxxess Metalsmiths Studio Furniture ei BageSere Instruction Sheet Paterson N J 07503 Config u raxx Side Wing Racks Made with pride in the U S A If you are adding an RB 22 to your side wing rack follow step 5 If you are not adding a shelf turn the unit on it s back add your rackmount gear and have at it Step 5 Place a reciever tubing whatchamacallits with silver knobs in the position shown and run 2 1 4 20 x 5 8 silver screws in through the holes into the table top Place the other reciever next to it and run in 2 more of the same screws Now carefully turn the unit over and get the shelf and ee the remaining tubes Upright Next screw the uprights
Download Pdf Manuals
Related Search