Chief SLB256 project mount
Contents
1. INSTALLATION INSTRUCTIONS SSB 256 SSM 256 SLB 256 and SLM 256 Interface Brackets SSB 256 SSM 256 SLB 256 and SLM 256 Interface Brackets are designed for use with Chief Series Projector Mounts See the specific installation instructions provided with the mount for additional installation information Unpack carton and verify kit contents If any listed parts are missing immediately contact a Chief Customer Service representative WARNING IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT substitute hardware Use only hardware supplied by manufacturer 1 Interface Bracket 1 Screw Phillips Flat Head Machine M4 x 16mm 4 10 24 Thumb Nuts 2 Screw Phillips Pan Head Machine M4 x 16mm 1 All Points Security Kit 2 Washer M4 1 5 82 Security Hex Key 3 Spacer 50 x 218 x 25 Towards oa Towards front of projector of projector SLB 256 SLM 256 Only used when installing SLB SSB interface brackets NOTE Specific to SSB style and SSM style interface bracket installation All appropriate screws come pre installed in the circled locations DO NOT attempt to substitute and USE ONLY this pre installed hardware for SSB style and SSM style interface bracket installation Installation Instructions WARNING OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT over tighte2. n screws when installing interface brackets NOTE Step 1 is only required when installing an SLB SSB interface bracket If an SLM SSM bracket is being installed proceed to step 2 1 Screw thumb screws onto 10 24 x 5 8 Phillips pan head screws DO NOT fully tighten thumb screws at this time Turn projector upside down on a flat surface 2 3 Place three spacers on bottom of projector aligning them with three threaded inserts on bottom of projector 4 Place interface bracket onto spacers on bottom of projector aligning the mounting holes in bracket with threaded inserts in bottom of projector and ensuring that triangle in bracket points towards front of projector Position two M4 x 16mm pan head mounting screws with two M4 flat washers into the outside threaded inserts and the M4 x 16mm flat head mounting screw into the threaded insert at front of bracket Tighten all fasteners at this time securing the bracket to the projector NOTE Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions in the All Points Security Kit 5 PP Chief is a registered trademark of Milestone AV Technologies All rights reserved R2 KA amp eons wes Milestone AV Technologies and its affiliated corporations and subsidiaries collectively Milestone intend to make this manual accurate and complete However Milestone makes no claim that the information contained herein cover
3. s all details conditions or variations nor does it provide for every possible contingency in connection with the installation or use of this product The information contained in this document is subject to change without notice or obligation of any kind Milestone makes no representation of warranty expressed or implied regarding the information contained herein Milestone assumes no responsibility for accuracy completeness or sufficiency of the information contained in this document EN o Chief Manufacturing a products division of Milestone AV Technologies 8802 002046 Rev00 ICJ ll E 8401 Eagle Creek Parkway Savage MN 55378 2009 Milestone AV Technologies e P 800 582 6480 952 894 6280 F 877 894 6918 952 894 6918 a Duchossois Group a ok Our Mounts Your Vision
Download Pdf Manuals
Related Search