SCOTT CMX-108
Contents
1. Switch to position The buzzer will turn to wake you up at the preset time 6 To turn off the radio or buzzer slide the Function Switch to OFF position or press the Alarm set button aARON gt SNOOZE FUNCTION When the radio or buzzer sounds press the Snooze button to switch off the alarm Approximately 9 minutes later the alarm will switch on again This snooze cycle will be activated up to 5 times within an hour period To stop the snooze cycle slide the Function switch to OFF position or press ALarm set button SLEEP FUNCTION 1 Set the Function Switch to OFF 22 position 2 Press the Sleep button The clock display will show 59 minutes The radio turns on and off automatically after 59 minutes 3 To reduce the automatic shut off time hold down the Sleep button and press the Minute set button to adjust to the desired sleep time 4 To set the automatic play for up to1 hour and 59 minutes press and hold the Sleep button and press the Hour set button once The clock will read 1 hour 59 minutes 5 To turn the radio off prior to the preset sleep time simply press the Snooze button AUX IN Connect an external LINE OUT to AUX IN socket on the top of the unit AUX IN CABLE NOT INCLUDED ANTENNA The FM radio has a flexible wire antenna on the back of the unit uncoil the wire and extend to its full length for best reception SPECIFICATIONS Power Source AC 230V 50Hz DC 9V backu2. lt gt SCOTT CMx108 amp MIRROR ALARM CLOCK RADIO INSTRUCTION MANUAL CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION To reduce the risk of electric shock do not remove the cover There are no user serviceable parts inside the unit Refer all servicing to qualified personnel The lightening flash with arrowhead symbol within the triangle is a warning sign alerting the user of dangerous voltage inside the unit The exclamation point within the triangle is a warning sign alerting the user of important instructions accompanying the product WARNING To reduce the risk of fire or electric shock do not expose this appliance to rain or moisture IMPORTANT DO NOT THROW BATTERIES IN FIRE THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING ENSURE A MINIMUM DISTANCE OF 5 CM AROUND THE APPARATUS FOR SUFFICIENT VENTILATION ENSURE THAT THE VENTILATION IS NOT IMPEDED BY COVERING THE VENTILATION OPENINGS WITH ITEMS SUCH AS NEWSPAPERS TABLE CLOTHS CURTAINS ETC DO NOT PLACE NAKED FLAME SOURCES SUCH AS LIGHTED CANDLES ON THE APPARATUS TAKE ATTENTION TO THE ENVIRONMENTAL ASPECTS OF BATTERY DISPOSAL USE THE APPARATUS ONLY IN MODERATE CLIMATES NOT IN TROPICAL CLIMATES DO NOT EXPOSE THE APPARATUS TO DRIPPING OR SPLASHING DO NOT PLACE OBJECTS FILLED WITH LIQUIDS SUCH AS VASES ON THE APPARATUS In case of misfunction due to electrostatic discharge the apparatus has to be reset by disconnecting it from
3. mains supply Where to place the item Today s furniture is coated with a wide variety of lacquers and synthetic coatings that are treated with an extensive range of cleaning products Therefore the possibility that some of these substances contain components that react adversely to the rubber feet of the item and soften them cannot be completely excluded The rubber feet of the appliance can cause discoloring to furniture surfaces If necessary place the appliance on a non slide surface If at any time in the future you should need to dispose of this product please note that Waste electrical products should not be disposed of with household waste Please recycle where facilities exist Check with your Local Authority or retailer for recycling advice Waste Electrical and Electronic Equipment Directive THE MARKING PLATE IS LOCATED AT THE BACK OF ENCLOSURE OF THE APPARATUS GB 1 LOCATIONS PARTS AND CONTROLS Outlet gt 1 Speaker 12 Mirror lens 2 LED display 13 Alarm indicator 3 Alarm set button 14 Tuning control 4 Time set button 15 Tone selector 5 Sleep button 16 Wire Antenna 6 Hour set button 17 Volume control 7 Min set button 18 Function switch 8 Aux in jack 19 Phone jack 9 Dial scale 20 AC socket 10 Dial pointer 21 Battery compartment 11 Snooze button 22 AC adapter POWER SUPPLY This unit is designed to operate with AC Adapter Included as main supply Plug one end of the
4. AC adapter into the AC socket then plug the other end into AC wall inlet The 9V type 1x006p not included battery is used for clock back up only LISTEN TO THE RADIO 1 Slide the Function Switch to ON position 2 Select the sound effect use Tone switch 3 For a better reception in FM extend the antenna 4 Adjust the Volume Control for a desired listening level and select your favourite station with the Tuning control To turn off the radio slide the Function Switch to OFF position a TO SET THE TIME 1 Press and hold the Time set button 2 Press the Hour set button to advance the hour display 3 Press the Minute set button to advance the minute display until the correct time appears on the time display 4 Release the Time set button The correct time is shown on display GB 2 SET THE ALARM 1 Press and hold the Alarm set button while repeating step 2 and 3 described under TO SET THE TIME to set the desired wake up time 2 To check the correct alarm time press the Alarm set button USING THE RADIO BUZZER ALARM Set the alarm as shown SET THE ALARM Follow the procedure in LISTEN TO THE RADIO to tune the desired station Set the Volume Control to your required listening level Slide the Function Switch to 2 position The radio will turn on to wake you up at the preset time To wake to the buzzer instead of the radio set the alarm as shown TO SET THE ALARM Slide the Function
5. p 1 006 Frequency range FM 87 5 108 MHz Dimension 133 L x 69 D x 133 H mm Weight 510 g Due to continuing improvement the features and the design are subject to change without notice ADAPTER SPECIFICATION Input 230V AC 50Hz 40mA Output 9V AC 400 mA GB 3
Download Pdf Manuals
Related Search