Da-Lite Advantage, 84" x 84"
Contents
1. D INCLUDED in ih 0 050 th ATTACHED TO MOUNTING BRACKET SELF TRIMMING FINISHED FEANGE CEILING 7 3 4 SEE DETAIL A 3 8 THREADED ROD NOT SUPPLIED HANGER BRACKET DETAIL A Printed in U S A 85778 Rev 6 072. The POWER PRESENTATION PRODUCTS Instruction Book for ADVANTAGE MANUAL WITH CSR Controlled Screen Return E DA LITE es DA LITE SCREEN COMPANY INC 3100 North Detroit Street Post Office Box 137 Warsaw Indiana 46581 0137 Phone 574 267 8101 800 622 3737 Fax 574 267 7804 www da lite com e mail info da lite com PRE INSTALLATION 1 Carefully unpack case from shipping carton DO NOT unpack fabric and roller assembly yet 2 Make sure to recheck measurement of case for proper installation clearance 3 Remove any protective foam or tape from case CASE INSTALLATION 1 Hang case and attach to support structure with bolts See suggested methods of installation on page 2 NOTE Carriage bolts can be installed anywhere along the length of the case The head of the carriage bolt slides into the variable position mounting channel It is recommended that the center is supported on cases longer than 7 feet 2 Tighten bolts until trim flange is flush with ceiling NOTE For proper operation screen assembly must be level after installation SCREEN AND ROLLER ASSEMBLY INSTALLATION If your screen was shipped with the motor and roller already installed skip this section 1 Remove access door First remove the 2 screws from the ends Fig 1 Be sure to support the door during this step to avoid injury Lift the door slightly and pull away from the edge of the case Carefully unpack screen and roller a
3. ssembly Leave packing paper on roller Remove two 1 4 20 nuts from one roller mounting bracket Slide bracket towards the end of the case 4 Insert one end of the roller into the mounting bracket The mounting brackets have a foam pad that the slat bar will rest against Be sure to install the roller assembly so the slat bar is positioned below these pads Fig 2 5 Slide the mounting bracket onto the roller pin Replace the 1 4 20 nuts securely Re install the access door Procedure is reverse of removal OPERATING SCREEN 1 Pull down on pull bail until desired picture area is obtained Lock into position as on a window shade Be sure surface is locked before releasing NOTE this screen will not lock into position in the upper portion of its travel 2 Tore roll the screen pull the picture surface down about 6 inches and start the fabric up quickly and release Large picture surfaces are heavy and will start up too slowly to prevent the locking pawl from catching unless help is provided If the locking pawl catches pull the picture surface down and start the surface up rapidly The CSR feature of this screen will allow the fabric to retract rapidly until about the last 6 12 inches of travel then it will slow and retract gently into the case FIGURE 1 FIGURE 2 FOAM PAD REMOVE 2 SCREWS TO REMOVE ACCESS DOOR MOUNTING BRACKET ADVANTAGE MANUAL INSTALLATION VARIABLE POSITION 3 8 THREADED MOUNTING ROD NOT CHANNEL
Download Pdf Manuals
Related Search