Pyle PDWM2500 microphone
Contents
1. DUAL VHF WIRELESS SYSTEM OPERATION MANUAL Thank you for buying the PDWM2500 Wireless System Please read through these operation instructions so you will know how to operate your model properly After you read it put it away ina safe place for future reference CONTENTS PI Precautions P Hand held microphone P3 Receiver unit operation PH Installation P5 Trouble shooting P amp Specifications PRECAUTIONS e Avoid exposure of the system to rain or moisture e No user serviceable parts inside the system Refer all servicing to a qualified technician only Handle the wireless system carefully dropping or other shocks may cause failure e Avoid using the system where it may be subjected to heat such as direct sunlight near radiators or other heat sources Should any liquid be spilt on the system stop using it immediately lt may be possible to dry the system but you should have it checked by a qualified technician before using it again Take care with the main power adapter and lead If damaged in any way do not use the system and refer to a qualified technician for repair e Only use the system with the supplied components Do not attempt to use with any other main power supply adapter If the wireless system is not going to be used for a while remove the battery to prevent leakage In the event of electrolyte leakage inside the battery compartment carefully remove the leakage with a damp2. cloth Take care not to get battery electrolyte in contact with your skin however if it does wash your hands under a running tap If electrolyte comes into contact with your eyes seek medical advice immediately e Only replace the battery with the same or an equivalent type Please dispose of old batteries in an environmentally friendly manner in accordance with the relevant legislation e Do not use any solvents to clean any part of the wireless system HAND HELD MICROPHONE UNSCREW BATTERY COVER TO INSERT BATTERY LOW BATTERY LED POWER SWITCH PWRLED MUTE SWITCH BATTERY COVER OPERATION 1 Unscrew the battery cover at the end of microphone put a 9V battery into compartment with correct polarities then close the cover 2 Move ON OFF switch to ON position PWR indicator comes on blue If it doesn t come on please check the voltage of battery or polarities If the LOW indicator comes on this indicates the battery is dead Please replace with a fresh battery 3 The MUTE switch cuts off audio output without powering off the microphone Move the switch down to engage the mute feature and up to turn it off RECEIVER DUAL VHF WIRELESS SYSTEM LEVEL RF A RF B LEVEL PDWM2500 ANTENNAB OUTPUT JACK DC POWER IN ANTENNA A OPERATION 1 Pull out the antennas A and B Make sure they are completely extended and vertical 2 Insert one end of attached audio cable into AF OUT on
3. rear panel and the other end into MIC IN or AUX IN of amplifier or mixer 3 Connect the power adaptor from DC 12V of receiver to a main power socket 4 Switch on the receiver The power indicator comes on 5 Switch on the microphone The RF indicator on receiver comes on green The LEVEL indicator will light up when you speak into the microphone Adjust the volume by VOL A and VOL B control knobs INSTALLATION Using the supplied audio cable connect from the AF Output jack socket to the MIC IN LINE IN socket on amplifier Connect the mains power adaptor from DC 12V jack to a suitable mains power socket Installation Location At least 3 ft above ground level At Least 3 ft away from wall LE AMPLIFIER SPEAKERS AF OUTPUT DC 12V 200mA MAINS POWER ADAPTER TROUBLE SHOOTING The wireless microphone is not Turn on the wireless microphone The on air The microphone receiver is not Turn on the microphone receiver indicator does turned on and the connected audio equipment not light up The microphone receiver is not Turn on the microphone receiver connected properly and the connected audio equipment The battery in the wireless The microphone receiver is not Turn on the microphone receiver turned on and the connected audio equipment No sound The connected audio equipment is Turn on the audio equipment not turned on he speakers headphone
4. s are not Connect the speakers connected to the audio equipment headphones The battery in the wireless microphone is weak Replace the battery The sound is distorted The AUDIO OUT on the receiver Adjust the volumecontrols is not set correctly The distance between the wireless Move the wireless microphone away from the speakers or A howling noise IS ee ee change the direction of the heard from the microphone kers speakers The battery in the wireless microphone is weak Replace the battery SPECIFICATIONS A Overall system Oscillation mode Carrier Frequency Range Frequency Stability Modulation Mode Max Deviation Dynamic Range S N T H D Frequency Response Operating range Operating Temperature B Receiver Sensitivity Image Rejection De emphasis Audio output level Audio Output Impedance Power supply Power Dissipation C Transmitter Mike capsule Pre emphasis Antenna RF output power Spurious emission Battery Power Dissipation Quartz controlled VHF 160 270MHz 30ppm FM E75KHz gt 100dB gt 60dB lt 0 5 80Hz 20KHz at 3dB Up to 240 Feet 20 50 C 6dB u V at S N gt 20dB gt 50dB 50us 1V p p 6000hms DC 12V 200mA lt 800mW Dynamic microphone 50us Built in housing lt 10mW gt 40dB one 9V battery lt 250mW
Download Pdf Manuals
Related Search